Search results for query: *

  • Users: B Todd
  • Content: Threads
  • Order by date

Forum search Google search

  1. B Todd

    Stock (OEM) Rear Spring Length

    Searching the threads for a definitive answer on the length of stock rear springs. Are they the same length, or is on longer than the other? I'm guessing the passenger side spring is longer. If anyone has their stock springs sitting around and has a moment to measure it would be much appreciated.
  2. B Todd

    KDSS valve screws, cruiser lean, stock springs

    I thought I'd throw this out there and see if I could bundle all these questions into one thread. I have a 2014 LC that has a bit of "cruiser lean" on the stock suspension. About 1.5" lower on the drivers side front and back with a full tank of gas. My plan was to see if opening the KDSS...
  3. B Todd

    SOLD  1991/Toyota/Landcruiser

    I'm posting for a friend that isn't a forum type of guy. I've wheeled with him and this 80 for years. I sold my 80 last summer and got into a 200. He has done the same. Here is his add: 1991 Toyota Land Cruiser with 192K miles. Vehicle didn’t pass emissions and I don’t use it enough to...
  4. B Todd

    SOLD  Colorado: 1997/Toyota/Land Cruiser 2x Locked

    1997 Toyota Land Cruiser. 198,000 miles. Maintenance in Last 10,000 miles Cooling System -PHH -Heater Control Valve/hoses -Radiator -Blue Fan Clutch (WitsEnd) -Thermostat -Flush (Toyota Red) Front Diff Fluid Transfer Case Fluid Rear Diff Fluid Transmission Fluid Front U-joint (Cruiser...
  5. B Todd

    U-joint cap not tight

    Finally getting around to replacing bad front u-joint. When trying to remove c clips from bad one, it was odd that the cap was spinning in the yolk which made removing the clips a little challenging. Upon installing new u-joint I could basically press the caps in by hand. Little tighter than the...
  6. B Todd

    I should have listened.....35's

    A couple years after sending my diff to Zuk to have it rebuilt and a Harrop locker installed I'm thinking about making the switch from 33's to 35's. I know, I should have re-geared at the time but I was "never" going to be interested in a bigger tire size at that time. I refreshed everything...
  7. B Todd

    For Sale  Wits End Tire Leveling Kit

    http://absolute-wits-end.com/80-series-tire-leveling-kit/ $50
  8. B Todd

    Garaged vs. Curb

    Who garages thier 80 vs parks outside? I've lost 3 of 4 flares. Major gouge down drivers side. Pin stripes down both sides. Not exactly a collectors piece anymore. Rust free Colorado vehicle though. Thinking of putting the daily civic in the garage this winter so I don't have to scrape in...
  9. B Todd

    Flare holes and rust

    I harrop locked my cruiser this winter and have been hitting much harder trails this summer. I finally managed to rip one of my flares off. I'm not concerned about the look as it has suffered some other trail damage this summer as well. However it is rust free spending most of its life garaged...
  10. B Todd

    Spotted Downtown Denver Sunday 05212018 LX450/FZJ80

    Yesterday I was driving through downtown Denver and spotted what I think was a built LX450. Tube bumpers, deflared. I think the front had a possible stinger on the front. Parked on 22nd St before Broadway. Reminded me of Nay's rig, but wasn't green. It was what I would consider a perfect...
  11. B Todd

    Harrop E-Locker install questions

    I bit the bullet and decided to buy a Harrop E-locker. I decided to do some of the labor myself and pull the third member and ship it to Ken at gearinstalls.com. I've never pulled a third before, I'm hoping the forum could help me along the way. I have the third out and ready to ship. I had a...
  12. B Todd

    Aussie Locker off road

    So I've searched and read just about every thread about Aussie/Lunchbox lockers. Most questions are regarding steetability, and or how they perform in the snow. I've had my 80 for 3 summers here in Colorado and I'm ready to make the leap to a rear locker. My cruiser is not my daily driver...
  13. B Todd

    Navtec

    Just out of curiosity, I was wondering if anyone knew anything about the Navtec's fleet of 80's? I've searched the interweb, and mud and not coming up with much info on their cruisers specifically. Seems like a company with a fleet of 80's in Moab might know a thing or two. How are the...
  14. B Todd

    OME 2.5" and sway bar blocks/longer brackets

    I just installed 2.5" lift. Looking into ordering sway bar disconnects from LCP. Will I need sway bar spacer/longer brackets? I read through his thread and it says to cycle suspension to check clearances. Just not sure if I should order the blocks/brackets as well with just a 2.5" lift.
  15. B Todd

    Interesting thoughts on lifts

    I came across this researching lifting my cruiser. Seems like pretty solid logic to me, and transferable to our 80's, but wanted perspective of the more experienced. Just read OP since it derails like all forum threads. My thoughts on lifts
Back
Top Bottom