Just swapped in 100 series UCAs onto my 80. Can confirm bushings swap over just fine. However, the 100 arms are right around a 1/4" longer than the 80 UCAs. With a 2.5"-3" lift, I'm thinking this shouldn't create any driveline issues. Will see.
Oh no, sorry. Referring to the surface/boss where the brake line attaches. Admittedly I've been using the NAPA supplied crush gaskets... had no idea there was a difference between these and OEM. Still, it's worth pulling the little plug that covers this area just to see what you're dealing with...
FWIW It seems Napa quality is really slipping in the reman department. I'm currently trying to replace an 80 series front Eclipse caliper due to a seized piston, and while Napa is happy to replace it, the sealing surface on the replacements have either been gouged or very rough. I've refused to...
Trying to find a rear upper control arm for an 80. Original was damaged while installing new bushings. Anybody happen to have one lying around or know of a part out in the Phoenix area?
Guess I'm really curious about how much potential there is to gain by reinstalling the OME bushings. Is 3 degrees castor even realistic with CC bushings?
Thanks, I'll keep the brackets as an option down the road. Probably should've considered this option more strongly knowing that the CC bushings had some dissenters here on mud.
A little follow up. Pressed in the OME CC bushings using alignment marks from the plumb bob method. Castor measured at 1.80 and 1.86 degrees at each side. So I got them installed fairly even. Problem is that the steering wheel is very sluggish returning to center after a turn, to the point where...
Awakening an old thread as I get ready to install OME bushings (OME medium kit just installed). In Slee's instructions he briefly says to have "the vehicle on the ground, at normal ride height." Is it important to have the vehicle loaded at normal driving weight before marking the leading arms...
I'm looking for a part off the front passengers seat. It's the little plastic assembly that holds the worm gear/cap that typically gets worn out and replaced with the Gamiviti gear. I accidentally destroyed the shaft that the gear is pressed on to. Any chance you'd be willing to part out the...
I'm looking for a part off the front passengers seat. It's the little plastic assembly that holds the worm gear/cap that typically gets worn out and replaced with a Gamiviti gear. Any chance you'd be willing to part out the seat?Shipping to 49506.
Thanks
Hey Sofatank, I'm looking for a part off the front passengers seat. It's the little plastic assembly that holds the worm gear/cap that typically gets worn out and replaced with the Gamiviti gear. I accidentally destroyed the shaft that the gear is pressed on to. Any chance you'd be willing to...