When I bought 40 in 05 it had a Don Mackey Tucson badge. As best I can tell, Mackey never had a Toyota dealership but did sell used cars. Can anyone familar with this family of dealers confirm that? Trying to put together the history on my 40.
Thanks
Trying to resolve a PS steering leak. Leak is due to the different ODs of the connections on the cooling line and the low pressure connections on the reservoir and steering box. There's about a 4mm difference in ODs and can't clamp the smaller ends enough to stop the fluid leak. Thinking I...
I assume a clip of some sort. Can't track it down in the EPC. Anyone have a picture? This is PS, attached to the MAF sensor, holds the cruise control cable.
Everything + shipping from 20171
Run Channel - Toyota (62755-60010) - New, 96 FZJ80, may fit other years, 65.00 PENDING SALE
Tube, Front Brake (47314-60101) - NOS, FJ40, up to 01/79 does not fit my 3/79. Can send photos. 20.00 PENDING SALE
SOR - Clutch master and slave cylinder rebuild kits...
Noticed over the last year the OME bushing on the 40 were coming apart. This thing is mostly a garage queen do it doesn't see a lot of miles so I was surprised by the deterioration. Its 2.5 Dakar lift. So I decided to replace them. As I was installing the rear of the springs I noticed that...
Please confirm that the alignments of the dots on gears confirms I have the engine at TDC. Also, please confirm I need to keep trying to get the match marks to sync up. Please
Finishing up radiator install. There is a molded plastic bracket on the DS of the shroud. A clip attaches to it and holds a trans cooling hose.
Issue/question is the hole in the bracket is too big for the clip, It's the right clip. I broke the old one off so some how it was attached. I'm...
Need help identifying these two clips. Both have numbers stamped on the. One has 25, the other 13.
Both came out of the engine compartment.
any ideas on specific location and part numbers?
This may be a stupid question. 79 FJ40. Thought my rear door lock cylinder was bad because the key would not come our when the door was unlocked. Well...ordered a new one, installed it, same deal. Took it out, turned the square shaft a quarter turn and reinstalled. Now it won't come out when...
Rebuilt my rear axle hubs over the weekend for the second time. Made me think of a couple questions. Maybe dumb questions.
First, what is the purpose of filling the hub with grease? Is this to ensure the bearings remain greased? I get the front with the biff in there.
Second, maybe I just...
Finally getting around to installing my JDM fogs on the 80. I was planning just running them with a relay and OEM switch via battery etc..
I wasn't planning to wire them in to the factory lighting. i found this VA state inspection guide on the VA state website. Is this blurb saying they...