Search results for query: *

  • Users: Vision19
  • Content: Threads
  • Order by date

Forum search Google search

  1. V

    Throttle icing up..?

    Good morning everyone, Temps are getting cold here in AK. This morning was -30 F. I had the cruiser's (94) block heater plugged in all night. I let it warm up for 10 mins before I started the drive to work. After 5 minutes of driving, my throttle became stuck open at about 3000 rpms. It would...
    • Vision19
    • Thread
    • alaska low temperature throttle throttle icing up
    • Replies: 12
    • Forum: 80-Series Tech
  2. V

    Oil consumption increase - oily intake

    Good morning, I am wondering if anyone has any further ideas of tracking down my oil consumption issue. I went from using a quart every 1500 miles to a quart every 200-400 miles. No smoke out the tail pipe, no substantial leaks on the ground ( rear main seal has a leak but it can't be in the...
  3. V

    Transfer case with metallic tinted oil

    Hey everyone.. looking for a few opinions here. My 94 80 series has a gear whine that is most audible in the 58-65 MPH range (I have driven with both F+R drive shafts disconnected seperately to try to narrow down the noise - no change either way). While not horrible, it is noticeable. I put new...
  4. V

    For Sale  SW Minnesota: OME 2.5" Springs (850 + 863) SOLD

    I am getting rid of these springs as they did not suit my intended purposes. They have exactly 5,461 miles on them (no off-road miles). I bought them from Slee. OME 2.5" Lift 2850 is recommended for vehicles with a aftermarket front bumper and winch installed. Using this spring without constant...
  5. V

    SOLD  gone

    gone
  6. V

    SOLD  SW Minnesota: gone

    gone
  7. V

    De-modding - am I crazy?

    Hello all, So I purchased a 94 LC last fall. The PO had installed nitro 529 gears (factory lockers) with dynapro 35” tires. It currently has OME springs and castor correction bushings. I stepped down from Dobinsons 3” flexicoils because my castor was bad and it didn’t drive well. I have done a...
  8. V

    Pulling front 3rd - time for axle rebuild?

    Hello all, So I'm still in the process of base-lining my new to me 94 LC. Its been way more work than I'd like it to be, but thats a story for another day. I am in the process of pulling my front 3rd member to send it to ZUK so he can fix whatever is going wrong in there. Of course that means...
  9. V

    Endless brake bleeding - And how to fix it

    Hello all, I have been very grateful for this forum and the resources it contains. I purchase a 94 LC several months ago and have been learning a lot since then. I recently replaced every hard brake line on the body/frame and all of the soft lines, as well as the LSPV. I thought I would share...
  10. V

    For Sale  92 4Runner 1kzte turbo diesel - south dakota

    The ONLY reason I am selling my 1992 Toyota 4Runner SR5 because I need to have a Pickup in order to haul my horses around. I bought this vehicle 3 years ago from a guy in Arizona. It has spent its entire life in AZ and CA, so there is nearly zero rust. It has picked up a little surface rust...
Back
Top Bottom