Any chance you could elaborated on what you did to prevent hitting the glass? I've realized that after aiming mine, both projectors are just barely touching the outer glass, creating a small rub spot. I need to fix it before it becomes a real problem.
My suspicion at this point is a few factors combined: lots of "warm up" idling that causes condensation and possibly too much gunk in the passage ways of the catch can. Once I open the throttle up while driving it sucks in all the excess moisture and voila, frozen butterfly valve. I have removed...
I pulled the intake boot off and I found considerable water inside the throttle body. I also disconnected the hose on the valve cover next to the PCV that goes into the throttle body and it is filled with oil/water vapor milk shake. I don't think that hose should be pushing air from the valve...
Good morning everyone,
Temps are getting cold here in AK. This morning was -30 F. I had the cruiser's (94) block heater plugged in all night. I let it warm up for 10 mins before I started the drive to work. After 5 minutes of driving, my throttle became stuck open at about 3000 rpms. It would...
So you have 70k into it, and you won't get all that back. Doesn't make any sense to me to sell it. You have to just start driving the thing. I fail to see how you wouldn't be bothered by driving a brand new vehicle on salty roads. Fluid film it and enjoy. Everything on this planet rots away with...
Have this problem also, 55-62 Mph. I replace my throttle cable for different reasons, but a new throttle cable did not fix the CC for me. Partsouq shows the CC cable as discontinued for a 1994. Still trying to find a solution.
I changed my oil and rotated tires. Performed a pretty thorough inspection. Found two bad ujoints, a leaking PS pump, leaking steering gearbox, and more rust..
Snapped a few pictures of the light output on my retrofits. Morimoto ds2 minis.
Low beams
High beams
Very happy with the result.
I haven't read any other suggestions here, so sorry if this is duplicate info.
I am an aircraft mechanic/pilot, and when we break-in new cylinders or whole engines, we run a mineral oil for the first 25 hours. The first 5 hours of flight we run the engine pretty hard and hot, changing power...
A retrofit will get you there. Many people up here in AK drive with light bars, but they are incredibly blinding. We don't have many rural roads, because well, we don't have many roads. It may be possible to find DOT approved aux lights though that have a good cut off
Depo housings and morimoto d2s mini projectors. Pretty easy to install. Took one evening per headlight. Check out theretrofitsource.com
I doubt there is a better solution than high quality projectors for low beams. Its the dark season in AK and I like the output while not blinding traffic. The...