Search results for query: *

Forum search Google search

  1. SimplyTanner

    3vze. Zero compression on driver side cylinders.

    I have a 1993 4Runner with the 3.0l v6. It seemed to have a new lack of power last week, along with a low idle. Then Friday morning it died leaving my house, and wouldn’t start again. I have spark at all six plugs, I’m also getting fuel. Further diagnosis revealed that there is ZERO...
  2. SimplyTanner

    My steering locks up! 2nd gen Runner

    Hey guys, here's a fun one... Yesterday while in my '93 4Runner I drove through a 6" deep puddle in a parking lot. The usual big splash occurred and then my steering instantly locked up. Meaning, I could barely force my steering wheel to turn in either direction. After 15 seconds or so of...
  3. SimplyTanner

    Typical 4Runner rear sag!

    Hey guys, my '93 runner has finally hit bottom, literally. I planned on replacing the coils with stock length springs and use airbags to help out. Now I'm leaning towards 2" lift coils and possibly still bags later on. Anyone have a brand preference? I'm sure there are many threads on this...
  4. SimplyTanner

    No clutch! 2nd gen runner

    1993 runner, 3.0L with a manual (R150f). Well, the last week or so I have had to put the clutch pedal ALL the way to the floor to disengage. Then yesterday, while driving, my pedal stopped returning and I could barely disengage the clutch. I Milked it home and discovered I was slightly low on...
  5. SimplyTanner

    Wanted  1993 4runner - Need control arms!

    Well, it didn't take me long to bend some IFS parts on my '93 4Runner. That massive tree root came out of no where I swear! At first I figured I tweaked my steering really good, but upon further inspection the top of my passenger side tire is now about 1/2" closer to the body then the driver...
  6. SimplyTanner

    1983

    I just found these, and though I would share. If anyone really needs one, message me.
  7. SimplyTanner

    How much should I sell my 1983 seatbelts for!?

    I am selling an entire driver and passenger set of stock seatbelts with hardware from my '83 pickup to a fellow Toyota owner in Maui. I have no idea how much I should ask. Everything works great. Used but loved. Any thoughts on price?
  8. SimplyTanner

    2nd Gen 4Runner Antenna.

    Does anyone have a factory part number for a '93 runner auto antenna? Even a picture for visual reference would help. The motor works, I'm just missing the antenna and 'gear strip'
  9. SimplyTanner

    R&P swap from ADD to non ADD

    Does anyone know if the ring and pinion from a non ADD diff is the same for and ADD diff? It seems the only difference is the needle bearings in the ADD. Which I believe is actually part of the carrier and the housings are identical. Any help is greatly appreciated, thanks.
  10. SimplyTanner

    ADD vs Non-ADD, needle bearings needed?

    Is it possible to remove the oil seal on a Non-ADD Differential and bolt up an ADD axle tube? By removing the seal, the tube and ADD system gets oiled. The only difference I see is that with the ADD system you get needle bearings, and the Non-ADD diff only has the machined in "bushing" with oil...
  11. SimplyTanner

    2nd Gen four wheel drive hard shake and violent steer

    Hey, I'm new to the site and forum. It's obvious there are some smart people here! Hopefully someone can help me, I Just picked up my first 2nd Gen four runner. Truck drives and steers great in 2H. But in 4H or 4L it's hardly drive able. It shakes and shimmies hard and will pull the steering...
Back
Top Bottom