Rebuilding my HF1A transfer case and H151F transmission due to some issues with shifting into 2nd and some leaks. I used this link from Landcruiserclub.net as well as a 100 series FSM to guide me through this. It's not too complicated...just lots of layers. Transmission jack is a must and I...
I had a couple of leaks here and there. 2nd gear was slow to shift. The transfer case would pop out of low. So I decided to bust into both of them and rebuild. I think the transfer case and transmission are from a mid 1998 FZJ80 but not 100% sure. Through the tear down now with some new...
Need some assistance in identifying this oil return for the idler bearing at the rear of an HF1A transfer case. Unlike the rest of the oil returns, this one is plastic; and its broken. I have been unsuccessful in finding a part number even with parts diagrams. I suppose I could fab one up but...
I have a newish check valve and grommet for a FZJ80 brake booster. I bought these thinking they might solve my brake booster issue but unfortunately I needed a new booster. I installed them once but they didn’t solve the problem I pulled the booster and pulled these out.
$30 + shipping for both.
I have a used sector shaft and pitman arm. They are in good shape spines are straight with some minor scoring on the sector shaft teeth. I pulled them from my gear box when I rebuilt it and swapped to a 105 pitman arm and sector shaft.
$20 + Shipping.
1995 FZJ80 with H151 transmission - $15700
So I am reluctantly selling my ’95 FZJ80. I purchased this rig in July 2018 and I have loved working on it with my kids and taking trips with the family but unfortunately I need to sell it. Vehicle title is clean. VIN: JT3DJ81W9S0105997. Odometer...
How much front axial play is okay? The only thing I can find in the FSM is "minimize" axial play. Essentially it looks like it is based on the snap ring width on the bearing and clutch to "minimize." I looked through the FSM and searched but I cannot find a spec. I just replaced the front...
These are 3.25 inch drop brackets for the front radius arms on an 80. They are made by Possamai suspension from Venezuela. These were too short for me based on my lift and caster so I pulled them and put in Slee arms. $50 + shipping. Columbus GA.
Matt
Purists, avert your eyes...
5 min
$0.50 in tan vinyl
Spray adhesive
Heat gun
It isn't perfect but it will do for now. Really easy to do. YouTube has quite a few videos on vinyl wrapping stuff and can help.
Old:
New:
So I bought the wrong bearing that I needed. This is for HF2A and HF2AV 80 series transfer case rear output shaft.
Toyota Bearing PN is: 90363-50005
$10+shipping.
So I stumbled on this while trying to figure out a way to bench test my ARB lockers and wanted to share.
It turns out that the female fitting at the end of a Harbor Freight air blow gun (I assume other brands as well) is 1/8 in. BSP. So the 6mm press fitting to 1/8 in. BSP coupler that comes...
Selling a used ABS unit pulled from a 1995 FZJ80.
$50 + shipping.
ABS Unit Side by ArmyFJ posted Aug 15, 2018 at 8:57 PM
ABS Unit Top by ArmyFJ posted Aug 15, 2018 at 8:57 PM