I am pick gears for my SAS and definitely will DD it. According to the chart 5.29 is my number but most offer 5.13 or 5.38. some cases my axle might be limited to 5.13?? does anyone daily drive on this gearing? Which is better? Does it make a difference?
I read on other posts where axles were sticking out of the frame, to the side, inches. I am just a half inch difference from being centered is this a big deal? I am also ~2.4° on my rear pinion angle, is this too much? what are other 100's at?
Hey guys I am looking to find a place near Butte in any direction. You guys have any Intel? I figured you guys would be the best place to find suggestions. If this thread is in poor taste please remove it, no worries.
During some night time snow wheeling over Judith Peak in Montana. I broke something while going through deep snow drifts, waist deep snow, 200 point turn around or pulling the idiots out of the ditch in a car (because driving late night with no; gear, clothes, cell services, with the intent to...
During some night time snow wheeling over Judith Peak in Montana. I broke something while going through deep snow drifts, waist deep snow, 200 point turn around or pulling the idiots out of the ditch in a car (because driving late night with no; gear, clothes, cell services, with the intent to...
Hi guys, I'm looking for local places near Lewistown to go explore. Does anyone have any pointers?
I wheeled through some good snow to Crystal lake today and I also made it to the top of Judith peak and lost the track where it turns really skinny in the trees. Tore off a tie down loop on my...
Free to mud members only
EVERYTHING around my lift. the complete expertly removed AHC system (shocks, hydraulic lines, reservoir, accumulators, globes, all in perfect shape). springs, torsion bars. a massive box of good parts.
I will never get around to selling this stuff, and for the most...
Hello ladies and gentlemen,
I am new to MUD so go easy on me.
I have always wanted a 100 series and I have finally bought one and intend on turning it into a wheeling SLEE machine.
I am going to document the entire process good or bad I will upload my progress. I have searched the forums...