I do. I have 222V/223V combo. ARB bumper front with M8000 winch. (50lbs) White knuckle sliders, and rear 4x4 Labs dual swingout with a 35" MT on the rear driver left. Empty in the trunk. I have a HEAVY X2 battery. Even with the taller springs installed on driver side (like they are supposes to...
That would make sense. Thank you. I suppose when one side compresses it pushes air over to the other side. So when going through a dip and both wheels move up together at the same time I won't get full compression of the springs, right??
Good morning everyone. From those that have installed airbags inside your coils springs, have you noticed any decrease in articulation? Will these firestone red airbags stop my springs from completely compressing?
Good morning everyone. I just installed new Dobinson c59-223V coil springs on my 80 this morning. After I put it all back together I have my ABS light on. When I go 30 mph and slam the breaks it doesn't lock up, so it must be working right? My axles dropped down pretty low when I installed them...
I was wondering (when you get a chance) if you could send me a picture on the other side of the case where I circled it in red. I'm trying to see where that breather tube connects into.
Thanks for the pictures. This helps a lot, especially because these are hard to see since they are right under the floor board. How then does the transfer case breathe??
I am looking at my breather tube that comes out of the top of my transfer case. I have a little bit of oil coming out of my front output shaft after a new bearing and seal. (shaft not grooved either) I can not blow air in or out of the check valve. Is this electronically controlled? The reason I...
I am looking at my breather tube that comes out of the top of my transfer case. I have a little bit of oil coming out of my front output shaft after a new bearing and seal. (shaft not grooved either) I can not blow air in or out of the check valve. Is this electronically controlled? The reason I...
About 6 months ago I noticed I had a leaking front output shaft on my transfer case of my 1996 LX450. I replaced it with an OEM Seal and OEM bearing. The bearing I pulled out looked and felt perfectly good, but I bought a new one anyway. Today I have oil coming out of the same seal again. I...