Good luck with the install man!
Trying to find other spots in socal to test all the work I've done to the 40.
Drove it today on the freeway for the first time going 60mph. At least 1 test done. Just need to test it on dirt :)
Hi everyone,
Looks like azusa canyon ohv opened on jun 19. I just got my 40 running so looking to do a little shake down. Anyone up for going this Saturday June 26 in the morning?
John
Hello everyone,
Owned my 75 fj40 for a couple years, never wheeled her. Specs are
- 305
- 700r4
- front disk (not sure which kind) rear drums
- stock transfer case with twin stick
- 33x10.5 on stock rims
- power steering
Since I've got the front driveshaft installed, I'd like to go...
Just circling back for the next guy,
I used the advanced adapter kit and brought it to driveshaftpro and built me a whole new driveshaft with the advanced adapter kit.
I had to use 7/16 grade 8 bolt on the differential side. Can’t find the M11 bolts.
Hi everyone,
I purchased this 75 40 a few years ago. It has already been converted to a 305 mated to a 700r4 and stock transfer case. It did not come with a front driveshaft.
I've been trying to find pictures of what an advance adapter 716370 : Toyota Land Cruiser Ultra Clearance Front...
I have a bike rack mounted to the tire carrier. When I have the bike on the rack, the weight tends to peel the carrier down. Any ideas on securing the carrier to the tailgate when the bike is on?
Hey everyone,
I've been collecting pieces to put together the factory soft top bows on my 75 fj40... I believe I have all the hardware that I need to have the bows complete. The last pieces I need are all the bolts to put them together. What are the bolt sizes to bolt all the bows unto the...
Thanks guys!
Other than marring the top of the cap, any other issues in terms of functionality or tolerances etc if I use a long screwdriver and mar the cap?
John
Hi Guys,
Was hoping to have been posting to the "What have you done this week" thread, unfortunately I'm stuck.
I was trying to get the bottom front bearing out of a 75 fj40 on the knuckle.. I've attached a pic.
Any tips on getting this out? Or special tools should I use?
Thanks,
John