Search results for query: *

Forum search Google search

  1. T

    Source for 4.3:1 gearset??

    I personally have never seen 4:30 gears. I know there are 4:56, 4:88, 5:29
  2. T

    SOLD Fort Worth, Texas. 1995 Fzj80 3x locked.

    I pm you
  3. T

    LX450 Spongy Brakes

    They said they couldn't undo the bleeder screw without breaking it.
  4. T

    LX450 Spongy Brakes

    Hello ih8mudders! I am having spongy brakes on my 97 LX450. I had the brakes bled on the front, but they couldn't do the rears, replaced the brake booster, and the brake pads front and rear are all with good padding left on them. The emergency brake is in good working order. I have read that...
  5. T

    Wanted 1997 LX450 passenger headlight and driver tail light

    I have a tail light on the way, just need the passenger headlight.
  6. T

    Wanted 1997 LX450 passenger headlight and driver tail light

    ttt
  7. T

    Wanted  1997 LX450 passenger headlight and driver tail light

    I'm looking for a passenger side headlight because mine has the glass broken on it. I also need the drivers side tail light because that is also broken on it. as far as I know the headlight has to be out of an LX450 so that I can keep my grille. The tail light doesn't matter. If you have one...
  8. T

    100 series brake pads on an 80

    I did the fzj100 brake pads on my LX450 and the brakes work better then before. I stop better with less input. No issues yet.
  9. T

    CDL locks but doesn't send signal after the underdrive gear swap, and I can't lock my axles.

    Thanks for your help! It is working properly now!
  10. T

    CDL locks but doesn't send signal after the underdrive gear swap, and I can't lock my axles.

    I took the actuator motor off and locked it while it was off. I then spun the big gear towards the front of the vehicle, and put everything back. When I press the CDL button, nothing comes on in the dash. What am I doing wrong? I even disconnected the harness to the T-case while on the...
  11. T

    CDL locks but doesn't send signal after the underdrive gear swap, and I can't lock my axles.

    I took the front indicator switch out and tested it and it came out good. And when I put a paper clip in the front actuator switch it turns the indicator switch on in the dash.
  12. T

    CDL locks but doesn't send signal after the underdrive gear swap, and I can't lock my axles.

    I installed the Under drive gear in my 97 LX450. The Center Differential locks but it doesn't turn the light on the dash on, so this makes it so that my differentials don't lock. I know that the center differential is locked because I hear it engaging, but the front output switch doesn't...
  13. T

    Replacement speakers

    I am replacing the speakers and radio on my 97 LX450. What is the best size where I don't need an amp or spacers to fit in the doors. I want to keep the stock grills and don't want to have to use a bigger amp because of my budget. Also what is the best replacement sub?
  14. T

    10% underdrive High range installed

    So just to clarify with the installation of this gear, you could technically have 35's without the need to regear to 4:88's? And this underdrive gear works with the 3:1 gears? But could these 3:1 gears be from any company, like trail gear?
  15. T

    Wanted LX450 A343F Transmission

    How many miles?
  16. T

    LX450 2nd gear issues continue. Please Help!!!

    I'll look into that switch tomorrow. Thanks! Any other suggestions?
  17. T

    LX450 2nd gear issues continue. Please Help!!!

    I did replace the Solenoids. I'll check those connectors.
  18. T

    Wanted  LX450 A343F Transmission

    I am looking for an LX450 A343f Transmission that is in good working order with good mileage in the Colorado Area. PM me if you have one!
  19. T

    LX450 2nd gear issues continue. Please Help!!!

    I know this is a dumb question. But, where do you disconnect the Harness from?
  20. T

    LX450 2nd gear issues continue. Please Help!!!

    My 97 LX450 decided to start skipping 2nd gear at a stop light. The motor would rev to 4 rpms and it would then shift into 3rd gear when I took my foot of the accelerator. The check engine is on and the Mechanic said it was a code for a shift solenoid. So when I pulled the pan it looked...
Back
Top Bottom