So I was taking off my steering shaft protector to inspect my steering knuckle and whatnot. Then I thought to myself as I was looking at the protector "Is this thing really needed?".
The only thing I can see is that the rubber boot above the knuckle maybe compromised by the heat of the...
I just did mine last winter, took her down to bare metal, air chisel worked great. Took my carpet down to the local car wash and hung up the carpet and sprayed them down, its amazing how much dirt that carpet can hold and still not get it all out. Ordered a dye from detailking.com, it seemed...
Yes, I did see that liner with the logo and it does look pretty slick.
But this is more of what I'm after because I have some cruisercrap left over and thinking of doing the same thing.
Thanks for your inputs.
Just got rear ended at a stop light about a week ago, had to replace the rear lower gate (@$200 used) and driver side lens ($71 new) as well as rear quarter panel damage under the lens, $950+ total and that was just with primer on the damaged area. I opted to take care of the tailgate and lens...
Seriously, I mean really, tackling serious rust issues, got bored with that and fabed a roof rack, snorkel, shelving/bed, removing front diffs, fabed a new high capacity oil pan, battery cables, wiring, whats next...I wish you were my Neighbor.
Yea, did a little research since my posting and tried Super Clean...nothing. Tried oven cleaner...nothing. And you know I wanted to try bleach and muratic acid and just figured it wouldn't be worth it, but you mentioned acetone to remove any clear coat before application and that might be the...
I also had finger tight nuts on mine when I replaced my seals over a year ago. I think your fine, I only got mine firmly snug and just rechecked them every so often.
Nice, I'm liking it. That nutsert tool is expensive.
I'm going to look into these also, your right, its just a cover don't know why they wouldn't work.
Thanks guys great info.