Wiper mother in good shape that was working when I purchased it, I bought it for a spare but I know longer have a 60. I have a FJ40 and it does not fit to keep as a spare. I will take $60 plus shipping. Kitty Hawk NC 27949
A while back someone posted that they had the skills to repair the pre '79 wiper motors on this forum. Does anyone remember who it was? Does anyone know where I can pick one up? It rains a lot here in Hawaii and I would like to get my going again.
I have a 5.3 liter in my 60, I was hoping someone could post pictures of where the x-mitters for these are located on the engine. Right now I have neither. I was thinking of putting the new RPM gauge in the location of the factory gauge and was also wondering the size of gauge to use in this...
I've got gas, spark, and the timing is set where it is supposed to be. The battery is new and has plenty of charge. My compression is low across all cylinders, aprox 100 psi in all 6 cylinders. I find it hard to believe that the rings have failed in a 6 cylinders. The motor has about 5000 miles...
I need help, opinions, or a torch!!:mad: I have been trying to get the timing right on my Cruiser forever.
Heres the background info.
I put Downeys fuel injection on my cruiser. Ran fine for a while but could never get the timing right, the rpm was all over the place at idle, then after...
I seem to have problems with my timing, I'm running chevy tbi on my stock straight six. I was wondering where people are setting their timing at? The toyota shop manual says to set it at 7 btdc, and chevy shop manual says to set it between 15-25 btdc, and DUI, says to set it at 12 btdc.:hhmm...
The Cruiser starts a/ runs fine, but after any long drive that doesn't have stop/go traffic such as highway drives, the Cruiser idles real low and all over the place when I come to a stop. The brake pedal is also hard to press. When it is moving it runs a/ idles fine. I know that there is a...
I noticed that on my fly wheel there is a ball and a line. When I set my timing which one do I use. FSM says to aline the ball a/ another manual I have said it lined up on the line. Is the ball supposed to be centered? In the Toyota manual, it looks like the mark is before the ball. It says to...
This is a thanks to Pighead for answering the call and showing up this weekend on short notice and helping me to stab my engine. It was hot, but as promised there was ice cold beer:beer:. I still have a few things to finish up before it will start.
I've got it all buttoned up and have been driving it (not very far from home) and the timeing is still off a little bit but nothing that I can't dial in. My new problem is that it will not go over 45 mph. I checked the length of my new throttle cable and with the pedal all the way to the...
I've got my fuel injection installed and working some-what. It purrs when it is idling but as soon as I drive it, the engine starts to back fire and lurch. I read the faqs and am going to have my eprom looked at. But what has me confused is that my oil has a strong gas smell in it. I was...
First I would like to thank bsmith123 for pointing me in the right direction, the diode fixed my engine wpouldn't shut-off problem. The fuel pump continues to run after the engine is shut-off. Again, I open to suggestions. Thanks.
First a little info of where I'm at. I put a Downey fuel injection kit in my project Cruiser. I have a painless wiring harness in it as well. So the whole Criser has been re-wired.
Yesterday I started it up for the first time. It fired right up but my alternator pulley was hitting a bracket...
I have two brake boosters, Both for front disk brakes and both are Toyota. I would like $45.00 each, buyer pay shipping.. Can send pictures on request. Email me at tsanabia@mac.com:cheers:
Cleaning out the garage. Buyer pays shipping from 95842 (Sacramento, CA)
Aluminum Diamond Tread Plate Kick Panels a/ Side Panels-$25.00
Rear Heater-SOLD
VSS from 1975-$5.00
Voltage Regulator from 1975-$5.00
Charcoal Canister w/ Powder Coated Bracket-$5.00
Fuel Filter Bracket from 1975-$5.00...
I couldn't make swapmeet
FJ40
2 sets of mirrors,
-1 set have adjustable length arms a/ attach at window hinge $10
-1 set attach at door hinge $10
-1 complete axle from my 1975. Hubs, brakes, a/ third member all there $40
*would prefer local pickup, but will ship on your dime!
-1 Rear...