Hello All
Working on wiring up my 72 Fj40. Can someone tell me what lights should light up when you pull the light switch to park?
Painfull painless harness in progress :/
Finally got to hang some fun parts today! Thanks for the inspiration fellow mud members. I haven't posted much, but I have used the crap out of this site during this build. Thanks :)
6-72 fj40, is this line between the filter and fuel pump supposed to be a hard line? Both ends are threaded for nut and olive, but seems nuts to make a hard connection between motor and frame. Any advice is greatly appreciated.
Ryan
I am at a point on my build that I want to finish up the Saginaw power steering conversion. Looking for input as far as the tie rod/ drag link is concerned. Basically I only have mini truck arms and the sag box. It's the bigger bolt pattern not that it really matters for this question but? So...
Trying to sort out what has been cut on my dash. Did my 6/72 come with a radio hole? I'm planning on putting in a switch plate where the radio has been cut in by po, but am unsure where to set my patch left to right on the dash. The lower pad looks like it was cut too. Anyone have a dimension of...
How much clearance is needed between the top of the transmission and the hump? I swapped from a 3spd to a 4 on my 72 and the old hump is just touching the top plate of the transmission. Can I use some rubber on the bottom of the hump to raise it up or am I chasing unicorns here. The old hump is...
So I bought a new starter today. Ended up with this monster! Either I had the wrong one in there from the po or the parts guys have me the wrong one. Any thoughts?
So I spent some time this weekend searching about disc conversions, but could still use some mud help. I'm assuming this is a mini conversion with the solid rotor. Will I still be able to use the vented Fj60 rotors? Any help would be greatly appreciated Thx
Trying to mate up my four speed transmission to a three speed transfer case. I'm pretty sure Mark Offroad sent me the wrong bearing. Looks just like the bearing in the back of my three speed transmission. The transition gear won't slide on and I don't really want to try hammering it on. The gear...