Hey all... Bought a tractor mounted sickle mower that is up in Chino Valley. I live just north of Sierra Vista. Anyone from that area coming to Phoenix/Tucson or passing through?
I would be happy to compensate for time/gas if anyone is willing to help out.
Thanks.
Mike
I have a 2F that was a high-mileage take-out from an FJ60. Not sure which year but it should be a good core for a rebuild. PM me if you are interested. $700.
I have a need to travel from Sierra Vista/Tucson (Starting 10/22) to Phoenix (and back) twice monthly. Normally on the weekends.
If you need anything transported please let me know. Just looking to cover cost of fuel.
Thank you.
I have a need to travel from Sierra Vista/Tucson (Starting 10/22) to Phoenix (and back) twice monthly. Normally on the weekends.
If you need anything transported please let me know. Just looking to cover cost of fuel.
Thank you.
Mike
Posting this here as well as MudShip section. Picking up a truck in Salt Lake City, UT on Friday 8/19 and headed back to Tucson (through Flagstaff, Phoenix, etc.)
Check the classifieds, Craigslist, Facebook, etc. to see if there is anything you want hauled down. Plenty of space.
Thanks - Mike
Hey all. I am flying to Salt Lake City, UT on Friday 8/19 to pickup a new commercial vehicle.
Plenty of space to bring something back, if anyone is in-need of assistance.
If you need anything transported from Salt Lake City, UT to Phoenix or Tucson please let me know. I would appreciate the...
Hello,
I purchased a (barely running) Kubota RTV-X900 that is in Los Gatos (Close to San Francisco) CA.
If anyone is coming to AZ from San Francisco, I would appreciate help moving it.
I can pickup anywhere in AZ for the final leg, but hoping to put it on an existing transport.
Let me know...
Thanks for this write-up. I am replacing my firewall to compressor line and was looking for this information so I could have a custom hose made.
Did you by-chance have a typo in that Vintage Air P/N? I think 35883-VUG should be 35833-VUG. The one you list is a male fitting. The one ending in...
Looking that way unless I have other folks interested. I would need to remeasure my template, update the AutoCAD drawing and have them laser cut. Just too much to do if there are not enough folks to make it worth while.
I ordered a smaller (replacement) fluid bottle that I still need to mount. Trying to make space for a dual battery but just have not gotten to that yet.
I had to rework it slightly to make it fit. The AutoCAD drawing needs a few updates. If I get (5) folks interested I will send it out for cutting. That should bring the per piece cost down to about $40. Otherwise I will just make the template available and everyone can cut their own.
No, not yet. I was going to start one after I wrapped up the LX450. Hoping to get a good start on it this summer. I will post up a thread in the Copper State Cruiser clubhouse when I start.
I made a terrible mess cleaning this one up. Had half of it hanging out of the cabinet with plastic sheet covering the opening. Took me an hour just to clean-up afterward.