Search results for query: starter

Forum search Google search

  1. racevws

    Sticky Starter solenoid. Ugg

    So when I go to start Lexi, especially when it's cold, I might get a short grinding noise, and the starter will just spin. I let off the starter of course and usually the second (or third time yesterday) it will engage and start. Is it serviceable?
    • racevws
    • Thread
    • cold grinding solenoid starter starter solenoid
    • Replies: 3
    • Forum: 80-Series Tech
  2. JohnnyFish

    starter ground attach point?

    On a '96 1fz, there's a ground wire in the harness close to the starter power wire. Where does that ground attach? Frame? Starter bolt? I'm swapping an engine from a wreck and failed to document where I detached that one. Thanks.
  3. OmegaDude

    Starter Problem need advice

    I have been chasing a white rabbit for a long time dealing with my starter on my 1996 FZJ80, and I need a fresh set of "eyes". The problem I am getting is when turning the key, nothing happens. You can tell power is being drawn from the dimming of lights, but no starter action. In the past, I...
  4. jomichael

    91 FJ80 Starter Install with Pictures

    I've been dreading the day that I commit to replacing my starter and cables. I bought the cable kit from @Fourrunner back in January because I have that intermittent non start issue. I also decided to get a remanufactured Toyota starter from the dealership. Yesterday was the day and though it...
  5. R

    95 FZJ80 STARTER WIRING DIAGRAM

    Hi Guys Ime new to the Forum so iv had a bit of a search and cant find a wiring diagram for the starter motor on here anywhere exept for the ones you have to pay for, has anyone got a diagram please. FZJ80
    • Rough80
    • Thread
    • diagram fzj80 starter wiring wiring diagram
    • Replies: 3
    • Forum: 80-Series Tech
  6. C

    FZJ80 Starter Trouble

    My 97 LX450 only starts when I connect the starter control terminal to directly to the positive battery terminal via jumper wire. As of right now, when I turn the key to initiate the starter there is no click or crank at all. I replaced the NSS and the ignition switch and the no start/no click...
  7. Rapt

    Not Starting

    ...there is one loud click but doesn't start. I can hear the fuel injectors pumping fuel in. Battery is fine, spark plugs are fine. I'm guessing starter but with one loud click and no other noise I'm not for sure. Typically if I would wait ~5 minutes it would start when I tried again but it...
    • Rapt
    • Thread
    • battery ignition starter starting troubleshooting
    • Replies: 6
    • Forum: 80-Series Tech
  8. imnrut

    Painless hot shot kit (30202) install

    By chance, would any of the folks that have used this kit for starter issues mind chatting with me? I'm at a standstill in regards to wiring it up. Thank you for any help
  9. ripple

    starting problem...slow electricity

    ...sometimes 1, 3 or 4 or 30 tries and it starts. Maybe it's worse when it's humid. I just don't understand the time delay. I am replacing the starter again. Sometimes a jump start saves the day. I also just learned about issues with the neutral safety switch that i'm checking out. But, why...
    • ripple
    • Thread
    • electricity start starter motor starting time delay
    • Replies: 5
    • Forum: 80-Series Tech
  10. xetura

    Broken Starter Housing Connector Receiver

    I've searched high and low and the only thing I'm finding is the connector on the wire itself, NOT the one on the starter housing. I just pulled my starter so I could have more room to rewire my disintegrating NSS connectors and found the connector broken with some zip-ties holding the wire...
  11. B

    Starter issue

    When I turn the key sometimes the starter does not seem to get the message to start. If I turn the key to full off then try to start it starts like normal with full power to starter. Sometimes I have to move the key between starting to full off a few times before the starter turns the engine...
  12. Squash

    Ignition issues. Looking for a little guidance.

    If the starter is whining, and the engine isn't turning over then check the starter. Try quick key turns to get engagement of starter and flywheel. Sometimes a love tap to the starter with the wooden end of an axe or shovel will help. Lastly make sure you have a good battery.
  13. effjay80

    20 key turns to turn over engine, sometimes

    As Kernal asked is the starter cranking for the 20 attempts? Or are you turning the key 20 times before the starter cranks?
  14. Offroader93

    Starter Bolts/Bellhousing

    I have searched for awhile for a straight answer on where to get the 2 bolts for the starter. I beleive one is a bellhousing bolt, and one is a longer bolt of some sort. I searched Toyota Parts Deal and CruiserParts and could not find them. Either I overlooked them or i just can't find them...
  15. SnowCruiser1998

    91 FJ80 Starter

    Hey all, I keep running into the same issue where my starter contacts weld and the starter is no longer functional. I've had this happen every year around the same time 4 years in a row now, and while I know you can just replace the contacts, it's gotten pretty irritating. I'm wondering if...
  16. RPN

    1HDT will not start

    It sounds like the starter motor solenoid. Rebuild kits are available, but the 1hdt starter is a prick of a thing to remove - as you've discovered. Is the battery fully charged? Good luck.
  17. B

    FZJ80 owner @ Zion

    ...from the SW anyway. Since buying, I've replaced the tires and battery, done what I could with the undercarriage rust, probably needs a new starter. It has aftermarket seats and a new stereo. Spare tire winch has already rusted itself off, so I've got to see about getting a new one. Definitely...
  18. ToyotaMatt

    looking for the length of the 1FZ-FE Starter Motor mounting bolts 90119-12005 M12 x 1.25 x ?

    i am updating / upgrading as much OEM icing on the 28100- cake to my 1FZ-FE Starter Motor Kit's as i can in lock-step to my other various ones - RED OEM Yazaki main B+ Lug Boot - but the actual mounting hardware is a tad confusing , as i do not have access to a FZJ80 / 1FZ-FE ? - i see...
  19. RPN

    1HDT will not start

    1hdt is 12 volt. It'll be something simple - are the battery terminals tight? Is the lead to the starter solenoid tight? Were the starter solenoid contacts cleaned up or replaced? Thee isn't much else in there.
  20. Beech4wd

    1HDT will not start

    After rebuilding the starter my truck still will not start. When I put the key in the start position to crank all I hear is a buzzing and no movement of the starter. What could this be?
Back
Top Bottom