Search results

I just got my wheel back from @Birdhead last week and it is absolutely stunning. I am no where near the point of my restoration that I am in need of my steering wheel, but I didn’t want to wait to only find out that he no longer re does them, like @Rainman and the brake lines. So I went ahead...

I’m in the middle of replacing my rear ambulance door bottoms and am trying to come up with a way to do the bottom & side’s fold over seal. I’ve got the outside’s of the doors replaced and am very close to being ready to put the insides on, but I need to figure a way to pinch the outer edges of...

Hello Birdhead. I am here in Oklahoma City and I have a wheel that could use your services. I am ready when you are. Let me know. Thanks

Get your CDL and you can come drive for me, Heavy Haulin’. Check out some of our loads, JandBHeavyHaul.com

Once you get that CDL, never let it go. Drivers are in huge demand and companies are paying crazy money for drivers nowadays. Always a good back up plan if one is needed.

Yea, I just tried the shop by size, then click “continue without vehicle”, if you already have one saved and it worked for me

On those hood hinge pins, I took a “C” clamp and a small pin, put the clamp in a vise, just to hold it, and then tightened the clamp with the pin pushing on the hinge pin. You can either offset the clamp a little so the pin will push out the other side, or if you have a small piece of pipe, you...

You wouldn’t happen to have an extra triangle brace that made for the inside of the passenger rocker panel that you’d be willing to sell?

I’ll PM (private message) you. It should be the envelope up at the top

I don’t have any pictures of it, but I can get you one when I get home tonight.

Do you have his contact info or website?

Hello, I have one here in Oklahoma City, if your interested.

Thank you 77mustard40

Thank you much firemanj92.

Would any of you guys have a measurement from the top of the rear bed to the top of the wheel well, as well as the front on the bed, before it slopes downward for the heater? I’m replacing my bed and my drawing of the measurements was used by one of my employees to write down part #’s, not...

Beautiful build here Curtice. I was wondering if you might happen to have some more pics of your cart you built for your tub to sit on. Measurements to, if you would have them as well. I’m going to have to build one here shortly and I really like the one I’ve seen in your posts. Thanks

Is there a way of telling if this is a South American 2F? The serial # 2F 071509 shows it was built in 12/75. Shouldn’t it have a oval air cleaner set up? If so, is there any differences beside the air cleaner?

To make it exactly factory looking, might be near impossible. See the ribs, that are formed into the floor, right next to the screws, they curve inwards and the CCOT bed pan I have does not do that. It’s no big deal. I’ll just go without them, I was just wondering if they served some factory...