Search results

What are the proper bulbs?

What all should be flashing with the hazards on? Currently, nothing is. Only the tail lights flash when the turn signal switch is on right turn. I definitely suck at the electrical stuff so struggle is a good word to describe my work haha

Thanks a lot. Back at it tomorrow. Electrical has never been my strong suit

Still on the struggle bus. Would you say any or all of these grounds look inadequate?

Update: Still troubleshooting the turn signals/flashers with little progress. I replaced the marker light with the weak solder point. The housing was looking kind of sad anyways. Another note, both turn signals are aftermarket and absent of a 3rd ground wire. Not sure if that would cause issues...

Update: Still troubleshooting the turn signals/flashers with little progress. I replaced the marker light with the weak solder point. The housing was looking kind of sad anyways. Another note, both turn signals are aftermarket and absent of a 3rd ground wire. Not sure if that would cause issues...

Thanks brutha. I appreciate it. Really hoping it’s that simple

Yep, I understand they aren’t supposed to flash but they are when the turn signal/hazards are engaged. It’s barely noticeable but it’s there

Will do. I think I’m going to replace the entire marker and see what happens. Thanks

Hey there, New to the forum. I recently picked up a ‘72 40 but the wiring from the PO is a monstrosity. I’m having troubles with my turn signal and flashers. When the turn signal (left and right) is switched on with the lights switch off, I get the audible clicking noise but the turn signal...