Search results

Tha Thank you for the great information. What about the Holley sniper fuel pump? SNIPER DIECAST 340 LPH IN-TANK RETROFIT FUEL MODULE W/RETURN https://www.holley.com/products/fuel_systems/fuel_pumps_regulators_and_filters/fuel_pumps/efi_fuel_pumps/in-tank_retro-fit_fuel_module/parts/19-350 In...

I am considering installing a Holly Sniper 2300 on my FJ40 and the underhood portion of the install is straight forward. I am hung-up on how to address the electrical fuel pump. I think the in tank pump is the best option since the external pumps are known to fail but I am hesitant to cut a new...

Point of clarification. The 2,424 miles is over 10 years. I hope the pinion bearing in not shot because of low oil because of the increased angle.

2424 miles.

I did not. Great point! Thank you!

The diffs, trans and transfer case are all full. Everything is greased. I like your idea and I will trying it on Monday. THANK YOU!

Thank you! I am going to try a slightly smaller shim to see it if that eliminates the noise. There is no vibration, just an annoying noise at slow speeds or cornering. It sounds like a tire roar but I have ruled that out. It might be a bad component, but everything is new. I might just...

Thank you all for the responses. A rear ARB locker is installed and the springs are mounted with anti-Inversion greaseable shackles. I have add pictures of the drive shaft angle and shims. If I correctly understand everyones comments, I think the rear axle is pointing to high, thus a smaller...

I have a restored 1982 FJ40. During the restoration, I installed a 5-speed transmission and a set of ARB OME springs and shackles. The rear drive shaft was shortened and a double cardan joint was installed to accommodate the 5-speed transmission. Shims were used to get the right angle, but it...

I had the engine in my 1982 FJ40 rebuild by a local racing engine shop 5 years ago as part of a frame off restoration. Since the rebuild, I have only driven the truck 1,500 miles. It sucks when work gets in the way of your hobbies. Yesterday, while driving to Sandusky, I think I spun a...

Do you have the part number for these mirrors?

Does anyone have pictures of a BJ42 Hood Latch with cable release assembly? I am interest to see where it mounts to the bib and the latch mounting points on the hood. Thanks! John

I have a 1982 FJ40 with the rear heater that is under the center console. The rear heater value is leaking around the shaft. I have search for a new value but I have not been able to locate one. Does anyone have any ideas on how to repair a heater valve or know were I can find one. The valve...

Great Job!!! I have just completed a frame off restoration of a 1982 FJ40. I have included some pictures.