Search results

Any pictures of the LS430 shift knob installed?

It appears that 90311-47026 is listed as for a GX460 or LX570 (9031147026 - Oil seal; seal. Front drive shaft, right; oil (for differential side gear - Genuine Lexus Part - https://parts.lexus.com/p/Lexus__/OIL-SEAL-SEAL/63608653/9031147026.html), so I am not sure if it would fit on a GX470...

How has the rear suspension been performing? I already have the PCK installed, am going to install the Treay Oak KDSS spacers this weekend, and was looking at that Ironman 4x4 panhard bar.

Agreed on both counts!

I have had the Rago Fabrication brackets installed for a while now, they are nice brackets that work well. However, be warned that when I purchased the kit the hardware they provided was crap, the captured nuts that slide into the channel on the rack had to be ground down to fit. Rago was less...

Here is what I sent to Ben from Dissent Offroad: "... (1) Can the tire carrier be mounted on either side of the bumper? (2) The $750 "Tire carrier with aluminum riser and flip up table" includes the swing out, correct? (3) To mount the "Aluminum accessory tray" I first need both the...

I have not used these, my outer CV axle angle does not seem "extreme" enough to me to warrant. You might check out the GXOR Facebook group as I think I've seen a few posts about them. I have 2.5" of lift with no diff drop and didn't have any noticeable issues installing related to the lift.

I have sent an email, I'll respond with the replies here so other curious folks will have the answers as well.

Just want to clarify a few things: The tire carrier can be mounted on either side of the bumper? The $750 "Tire carrier with aluminum riser and flip up table" includes the swing out, correct? To mount the "Aluminum accessory tray" I first need both the "Accessories swing arm" and "Basket and...

Have you heard any from Rhino Rack on the GX470 backbone?

That is some impressive performance! Just to confirm, you did get the "Pro" version, correct?

Sounds like a great combination of parts! I do have a 2.5" lift installed as well, I didn't realize CVJ required a lift to use the high-angle boots.

I have heard nothing but good things about Blue Pit Bearings, and plan to purchase their assemblies once needed. From time to time I see rumblings about fake Koyo brearings from eBay and Amazon, and less than stellar reports of short life spans on "parts store" replacements.

As I have learned so much from this forum, I wanted to give a little back. This past weekend I replaced the cv axles on my 2006 GX470 with CVJ axles and wanted to give some tips and part numbers. Due to some incorrect information I received online I ordered a few incorrect seals and had to pay...

I was always taught to jack up the car and try rocking the suspected wheel: "...if you have the tire jacked up or the vehicle is on a hydraulic lift, you can check this one out yourself. Grab the wheel on opposite sides and attempt to rock it back and forth. If the wheel bearings are good, the...

This thread needs more pictures... Snow wheeling by bravoleader posted Dec 28, 2018 at 4:45 PM Snow wheeling by bravoleader posted Dec 28, 2018 at 4:45 PM

I wonder is the block off plates for the SAIS bypass kits would fix this problem: ASV Block-Off Plates

I run Falken Wildpeak A/T3W in 265/70/17 and rubbed really bad on the front portion of the fender liner.