Search results

Thanks for info.

Yeah, I found the fittings you can get at Summit or Jeggs it is 16mm 1.5 an the other 17mm 1.5 inverted flare to 6 AN or 3/8" JIC. Do you know which one is the high pressure?

I have attached pictures of my power steering unit, not sure what it is out of 4 runner? I have 16mm and 17mm male inverted flange fittings to thread into unit. I need help on which one is high pressure and low pressure? I see that there is a H on the 17mm fitting is this the high pressure...

Hello I have a few questions that I hope someone can answer. I had my 77 FJ40 2f engine rebuilt and installed a preformance kit which included headers, new Weber 38/38 carb and HEI distributor, I also installed new electric fuel pump and gas tank. Fuel System: do I need to install the fuel...

Thank you,

Hello looking for some help. I have attached pictures, I must be missing a bracket for accelerator linkage for the cable connection and attachment fittings. Was hoping to see what I am missing to purchase or make what is needed for this cable connection?

Thank you for help.

Thanks for help!

Ok thanks

Hello Happy New Year, I was hoping someone could help me to locate, or maybe it's missing, where the 4wd indicator switch is on the transfere case or where it may be? My reason I am installing one of the new Dakota instrument dashboard display and wanted to hookup that feature. Thanks Brian

What markings would tell me on my trans/transfer what year I have?

Thanks, the reason I was asking, some must have installed 1F flywheel, pressure plate, throw out bearing and hub on my 2F engine. I purchased 2F pressure plate, clutch plate, throw out bearing and hub. Was hoping the bell housing and trans/transfer would work. I do I tell if I have late 10/76...

I need some heIp! I have a 1F, 4 speed trans/transfer, bell housing, clutch pressure plate, flywheel. Will any of these 1F parts work on 2F engine? Thanks Brian,

I called Vintage Air the 15465-VTB has been discontinued. (my luck)

one more question where did you get, or can you help me with what bracket you used on the P/S

Thank you, you understood my questions, if i got this right inner (closest to engine) crank groove, P/S and W/P and on the outer groove on crank, W/P, AC and ALT. are you using 1/2" belts? where did you get 2 groove p/s pulley? When you using the Vintage Air bracket what bracket did you use...

TRYING TO FIGURE HOW TO BOLT TO MOTOR WITH PS AND VINTAGE AIR COMPRESSOR THE BRACKETS TO MAKE ALL BELTS TO WORK

Hello, Can anybody help me out? Need to get belts setup for 2F 1977 with adding mini truck power steering and vintage air? i have double grove on crank/balancer

Thanks for info!

hello, was looking for correct setup. i have 10/76 2F engine in 1977 FJ40, and am adding vintage air and mini- truck power steering, i notice that my harmonic balancer, crank pulley only has 1 V groove. Can somebody help with the correct answer to set up with 2 belts. I know i will need to...