Search results

  1. dilonious

    86 gets an LS

    Gosh, builds can take longer than you’d imagined.. Update:
  2. dilonious

    SOLD Idaho: 2f + H42 out of running 86 fj60 w/ 250k miles. **Price drop**

    Heading back to Idaho to finish this project, dropped the price on this motor+tranny to $1500obo! -Dylan
  3. dilonious

    SOLD Idaho: 2f + H42 out of running 86 fj60 w/ 250k miles. **Price drop**

    I pulled it in early-mid March.. it's in a climate controlled shop :) I'd be open to throwing it on a pallet!
  4. dilonious

    Dry Ice Blasting or Similar for Undercarriage?

    My plan is to paint it for appearance and then have it coated with some lanolin based undercoating before each rainy season. The blaster can do POR15 or other similar paints/coatings after dry ice blasting.
  5. dilonious

    Dry Ice Blasting or Similar for Undercarriage?

    I'm having my truck dry ice blasted in the next few weeks.. will update with photos. It's $900 to blast the entire undercarriage and paint. The before/after's I've seen are pretty damn great.. and you don't have sand/media stuck in your frame rails/nooks/crannies forever.
  6. dilonious

    SOLD Idaho: 2f + H42 out of running 86 fj60 w/ 250k miles. **Price drop**

    Land Cruiser Specialties: Engine Compression - #1: 156 #2: 152 #3: 155 #4: 135 #5: 150 #6: 159 (did a tune up w/ valve, timing, and carb adjustment at that time)
  7. dilonious

    SOLD Idaho: 2f + H42 out of running 86 fj60 w/ 250k miles. **Price drop**

    I didn't but I had it serviced in Oregon a few months back.. I'll see if they noted compression then.
  8. dilonious

    SOLD Idaho: 2f + H42 out of running 86 fj60 w/ 250k miles. **Price drop**

    I'm swapping in a LS motor and have the 2f + H42 available. The motor was running great, but had an oil leak or two. Everything in front of the transfer case included. Motor is currently in Boise, Idaho. $2k. Open to offers. **Price Drop: $1500obo**
  9. dilonious

    86 gets an LS

    I started my ls swap today! First day: engine, trans, transfer case all out. Tomorrow, I have a date with the steam cleaner.
  10. fj60 desmog

    fj60 desmog

    desmog photos
  11. dilonious

    Throttle linkage removal

    I'm not the best guy to answer this question and may have taken the linkage too far apart.. but the little half circle clips at the end of the rods just spring out to release the balls.
  12. dilonious

    Throttle linkage removal

    Carbureted*
  13. dilonious

    Throttle linkage removal

    Thanks! I wasn't sure if I was supposed to separate the clips.. didn't want to hurt anything. took 1 second :) This is my first carbonated car.. ha.
  14. dilonious

    Throttle linkage removal

    howdy. I'm replacing the intake/exhaust manifold gasket on my recently acquired fj60. My chilton manual sucks and I can't figure out how to disconnect my throttle. I have the two pins out. Any help? (I have one bar of 4g on my phone, makes searching hard to impossible.)
Top Bottom