Search results

  1. belouder

    Power Windows and Door Locks--Permanent Fix!

    Definitely interested in learning more! Especially if it means running new wire/components rather than disturbing old harness’ and have to chase damaged wiring to other components. Have you also done headlight wiring updates? Replaced fuseable link mess with fender mounted buss-bar/fuse panel? BK
  2. belouder

    Power Windows and Door Locks--Permanent Fix!

    At what point does it make sense to just completely re-wire these areas? I plan on doing headlight upgrade also along with eliminating the dangling fuseable links. BK
  3. belouder

    Power Windows and Door Locks--Permanent Fix!

    I’ve been following this thread in anticipation of doing serious work this winter in my ‘89 FJ62. A newb question: my windows operate properly but extremely slow-two need a bit of help to get them all the way up. I’ve replaced the track, wiper and door felt/rubber. Is running slowly primarily a...
  4. belouder

    1989 FJ62 Auto won’t start

    Also-there’s a cluster of electrical wires and connector just hanging loose next to solenoid-one thing I’ve noticed about this vehicle design is much of the electrical is stupid-ground switches, fuseable limks hanging off battery post, etc. I’m sure most folks have modified in various ways. I’ll...
  5. belouder

    1989 FJ62 Auto won’t start

    New to this truck and Toyota in general-is #5 cylinder counties ftom forward to rear? And where roughly would this plug be? Is it similar to a freeze plug? There are lots of hard lines going front to back-not sure if it’s rear seat heater, oil lines, trans cooler lines?
  6. belouder

    1989 FJ62 Auto won’t start

    So I was about to do the “remote starter” method to check starter itself and decided I’d first just try “tapping” on the solenoid and starter body. I’ll also cycled the canal wire connection (it was pretty wet inside) and then tried to start-fired right up!! I’ve used the “hit it with a hammer”...
  7. belouder

    1989 FJ62 Auto won’t start

    Hey I’ve got a problem I could use some help trying to troubleshoot. 1989 FJ62 w/350k miles. Original motor w/auto. Normally starts and runs fine-losing a bit if oil somewhere in the front and on side near starter. Last week it started getting hard to start-turns over very slowly but then...
  8. belouder

    SOLD 88 FJ62 Original Owner w 100k Original miles and Clean brown interior & dash I’ve seen on a FJ62 in New Jersey 4/27/2022

    Very interested in (order of priority): Center console Front grill including headlight trims Side view mirrors All the above would be great!! I'll pay for boxing and shipping to 83638
  9. belouder

    Euro/Aussie OEM side mirrors for FJ60

    The current after market mirrors I have are non-electric and I have no desire to install electric-already spending too much time updating headlights/windows/door locks to add more!!! I’ll check out the 70 series. And I gave sources that might be able to print a gasket-great idea!! Thx BK
  10. belouder

    Parting Out For (possible) sale: running 3F EFI and auto trans from 1989 FJ62

    Hey, I'm considering re-powering my truck (don't ask to what-don't want to go down that fire-hole!!) and need to see what market there is for the existing motor/trans-budget is tight and need to maximize my "investment". 3F EFI w/stock automatic trans. In the vehicle now and both run and...
  11. belouder

    Euro/Aussie OEM side mirrors for FJ60

    Curious about the 70 series mirrors-I have a '62 with what appears to be crap aftermarket mirror that shake and rattle. The truck has been in storage over the winter and when in the storage unit the other day I bumped one and it broke off at the swivel!! argh. I'm not looking for OEM but rather...
  12. belouder

    Anyone here build a 62 Wayne Tangen headlight harness? Having some troubles.

    I need to do this!! Are there any other resources along with the schematic such as part numbers and such? What bulbs did you end up using? And just so I understand how these wiring harness' interface: Does the harness use the OEM bulb plug as the "control" side of the relays that are direct...
  13. belouder

    Aftermarket charcoal canister and air intake bellows hose?

    FJ60Seth-finally getting around to ordering some of the hose you referenced. I'm not near the truck-did you use the 3" hose? or?
  14. belouder

    Aftermarket charcoal canister and air intake bellows hose?

    Had I actually look at the whole page-I would have seen that!!! Thx much for the resource-this will work great!
  15. belouder

    Aftermarket charcoal canister and air intake bellows hose?

    Thanks for this! It says 12’ lengths only-any chance you have a piece you want to get rid of? BK
  16. belouder

    Aftermarket charcoal canister and air intake bellows hose?

    I’m gathering parts in anticipation of cleaning up air intake, general tune-up and (hopefully) de-smog on my 1989 FJ62. It looks like the air intake hose with the “bellows” has a tear in it. Is there an aftermarket hose that folks have found works? OEM appears difficult to find. Charcoal...
  17. belouder

    '89 FJ62 fuel vapor collector line to engine

    FJ Silver-thanks for the ideas. I've blown air through the canister and it passes air. I'm going to do a de-smog in the next month and will most likely take the canister apart and see if it needs a clean-362K miles-I'm sure it does! BK
  18. belouder

    '89 FJ62 fuel vapor collector line to engine

    Can the canister be cleaned? Or only replaced? Be gentle-I’m new….
  19. belouder

    FJ62 FSM pdf?

    Thanks soooo much for posting these-Now I can start fixing stuff!! BTW-does anyone have a de-smog instructions PDF for 1989 FJ62 w/AT? Bri
  20. belouder

    '89 FJ62 fuel vapor collector line to engine

    I’ve read in a few posts that the excess vapors should travel up through a charcoal canister and then vent into intake manifold. But I’m not sure hence the post to see what is proper.
Top Bottom