Search results

  1. baldilocks

    Front axle shaft install support piece fell out of place, now loose inside housing. How to approach this problem? With photo.

    What I ended up doing was flaring the outside lip a little bit in three places, turned it around opposite side outboard and pulled it back in place using a combination of my fingers and then a pair of 90* needle nose piers that I was able to hook it and pull with. A few taps with a drift and...
  2. baldilocks

    Front axle shaft install support piece fell out of place, now loose inside housing. How to approach this problem? With photo.

    While doing a simple oil seal replacement on the front right I discovered this: I am able to put it back into it’s proper place but fit is loose which is no good. My initial inclination was toward mangling it enough to remove it through the end of the housing but I think that...
Top Bottom