Search results

  1. R

    Stereo Install Harness Help

    I’ve been staring at the electrical diagrams in my factory electrical manual but perhaps I’m too much a noob, because I can’t figure out exactly what each of these plugs (circled in green) does or where they are supposed to go. I think the large gray one on the left on my finger and one of the...
  2. R

    Grease and Service Your Driveshafts!

    Just a shout-out to the folks who have posted stuff to the driveshaft FAQ, and a note to the folks who have driveshaft maintenance on their to-do list. I was feeling some vibration at highway speeds and kept putting off the driveshaft maintenance. I kept convincing myself it's an old truck, I...
  3. R

    Clevis for Brake Booster?

    Anybody know where I can get a replacement clevis for the brake booster? This is the bracket looking thing that goes on the end of the brake booster push rod, that sorta connects the brake pedal to the brake booster assembly. When I tried to put the old clevis on my new brake booster, it...
  4. R

    Rotella 15w-40 experience in my 1FZE

    After scouring through lots of threads here about oil preferences, I decided to switch mine to Rotella 15w-40 with a fresh Mobil 1 filter. I'm a bit of a neat freak so I always clean and wipe up any oil splatters after an oil change. Typically, that's on the block where the filter is, on the...
  5. R

    Oil Cooler Cover Replacement Pics and Tips

    It took me a few days to trace a coolant leak to the oil cooler cover. Don’t let the size of the holes that these develop fool you, you can lose a lot of coolant. Under pressure it will squirt out. I ordered the cooler cover, hardware, and gaskets from PartSouq. As you can see, there was a...
  6. R

    SOLD SoCal: Complete Gray Carpet from ‘94 LC

    Selling the gray carpet from my 94. Never had a problem with it, but I’m trying to do a full resto so I ended up replacing it with a new one from ACC and adding noico underneath. It comes complete with the cargo and wheel well sections. I did take off the plastic trim for the electrical from the...
  7. R

    Hardware for Exhaust Manifold and Oil Cooler Cover Job (Replace bolts/studs?)

    Okay, so the oil cooler cover on my 94 started peeing out coolant and I finally got all the parts I think I need to fix it. The only doubt I have so far is whether or not to replace the hardware- all the studs/bolts on the exhaust manifold, for example? Can I re-use all these or should I...
  8. R

    Another rounded transfer case bolt thread

    If you're not familiar with my few previous posts, I got my 80 in December and I've been lurking on this great site and baselining my rig since. It's not my daily driver but definitely my Costco and Home Depot mobile on the weekends right now. Looking to get it ready for some tame wheeling...
  9. R

    SOLD Long Beach, CA: 80 series front axles, birfs, spindles, hubs, rotors

    Replaced all the parts you see in my truck with brand new stuff. I'm not wheeling and I don't have space to store so I figure it should go to a member who can put them to use as trail spares or re-condition them before putting them in their rig. The part that looks the worst is the driver side...
  10. R

    Plastic cone fell inside front diff

    I was almost done with my front diff fluid flush when the black plastic tip from the Mobile 1 75-90 quart fell into the front diff fluid hole. Has this happened to anybody on here before? I saw a thread about a tip in the t-case, but didn’t find one on the front diff. Will the tip get chewed up...
  11. R

    Axle Housing Damage?

    Hey guys, Started the front axle rebuild last week (thanks to Cruiser Outfitters for working during this shutdown). Birfs look thrashed so I got some new ones along with a rebuild kit. After I disassembled everything I noticed the inside of the DS axle housing where the birf goes, looked like...
Top Bottom