Search results

  1. Greg_B

    Registry Post Pics Of Your Modded 7x Series

    Wow, blast from the past. That was so long ago I don't recall if I started it that day or waited till the roads cleared, but it was my daily driver. It has been my daily driver for many years (though it has taken a year off here and there, especially when I had an MK2 Jetta) and will be again...
  2. Greg_B

    September Monthly Meeting at EBI 8PM, Sep 8!

    Hope you’re feeling better Bill. gb
  3. Greg_B

    92 HDJ81 radiator-where to get?

    A buddy of mine ordered 16400-17060 from @Japan4X4 just a couple years back. Too bad if now no longer available, though there are work arounds as discussed above. hth's gb
  4. Greg_B

    80 Series Toyota Oil Filter Options

    A Union Japan filter is cut open in this thread. hth's gb
  5. Greg_B

    Dud battery, or just not enough sunlight?

    In addition to what's mentioned above a battery hydrometer tester will let you check each cell. hth's gb
  6. Greg_B

    Worn engine treatment and other additives for old engines

    From my reading over the years diesel fuel in North America is some of the worst. Texas and California have the best requirements for cetane. Canada has a federal mandate of minimum cetane level of 40. What is cetane? Canada also has a renewable content requirement, which would look after...
  7. Greg_B

    1HDFT low oil pressure - Main bearings

    This winter I hope to update this thread linking in additional BEB threads and photos from this section Official 1HD-T 1HD-FT 1HD-FTE and 1HZ BEB thread - https://forum.ih8mud.com/threads/official-1hd-t-1hd-ft-1hd-fte-and-1hz-beb-thread.1109675/#post-12065913 hth’s gb
  8. Greg_B

    Worn engine treatment and other additives for old engines

    Discovered Hot Shot through Project Farm (he did a winter anti-gel video). Have not used any of their products other then Extreme and EDT. What application are you using the stiction Eliminator in? gb
  9. Greg_B

    Worn engine treatment and other additives for old engines

    Project Farm video using Engine Restorer. There is also a one year follow up. hth’s gb
  10. Greg_B

    Flexible solar panel mounting

    Not fully related to this discussion (unless the OP is using a Victron) but as a data point for controllers shutting down as its mentioned in the post above...I've had my Victron 75/15 shut down a number of times in hot weather in my BJ74. Took me by surprise on a hot summers day when I checked...
  11. Greg_B

    Secondary fuel filters and lift pumps

    Long thread on pusher pumps. This thread is a 13BT into a 60 series but in post #84 he talks restrictions and he used a pusher pump to solve. hth's gb
  12. Greg_B

    Anyone in the Seattle area recommended for PPI?

    @torfab is just north of Seattle: Torfab » The NW destination for Land Cruisers parts and service, including complete one-off custom built Cruisers, maintenance, suspension, and expedition builds - https://torfab.com/ as an option to contact and see. hth's gb
  13. Greg_B

    Cruiser Days! 2022 HOUGEN PARK Abbotsford August 6!

    Thanks for all your work @AJAEbj42 in making this happen again. Back yesterday from the loop with Squamish crew. Was a great time. Been years for me to to the complete loop via Mud Lakes...though if memory serves it was so long ago one or two times the loop was via Windy Ridge. gb
  14. Greg_B

    Cruiser Days! 2022 HOUGEN PARK Abbotsford August 6!

    Any camping location been chatted about or confirmed on other platforms after Cruiser Days or is the assumption it will be Chehalis per usual @AJAEbj42? @bladedog China Head loops sounds good. gb
  15. Greg_B

    Cruiser Days! 2022 HOUGEN PARK Abbotsford August 6!

    Planning to be in the LML around this time, so should be there if all works out. Looking forward to it. @bladedog Cruiser Days Squamish 2023 sounds good, with a campout up Indian Arm or some other local place afterwards! gb
  16. Greg_B

    4wdabc show and shine July 9 cruiser meetup

    Sorry to miss it this year but will be having fun up around Powell River. Enjoy! gb
  17. Greg_B

    1HD injector pump tachometer sensor

    This is for your 1992 1HD-T? I ordered a tach sensor a couple years back for my 1HD-T injection pump (March 1994 1HD-T if I am reading the casting on the block correctly, but should be the same part number for you...double check) and the part number I used is 83180-60070. This is the -...
  18. Greg_B

    June Monthly Meeting! June 16th at EBI! 8pm 1650 Broadway in Coquitlam

    Some verbiage posted up in the members section. gb
  19. Greg_B

    June Monthly Meeting! June 16th at EBI! 8pm 1650 Broadway in Coquitlam

    Sent you a text @AJAEbj42
Top Bottom