I am looking for the following TRD supercharger parts that I am missing:
1. Idler Pulley/Belt Tensioner Assy
2. Heater Pipe (return pipe)
3. Intake pipe (between air filter and throttle body)
4.TRD boost gauge (Tundra 1st gen one)
The first things I transfered from the JDM one to my rig after a serious wash was the roof headlining along with the overhead console, sun visors, rear speakers, electrical wiring and the brackets for the altimeter/compass "ecu" and A/C vents on the roof.
My empty rig:
The JDM one:
It's hard to get a scan-gauge hence my Landcruiser doesn't have OBDII.
Last summer I ran across a guy that was selling a petrol Landcruiser at a very very good price here, and it turned out that it was a rhd, 1997 JDM FZJ80 and the guy had no clue how rare those things are in...
Dragos80, in the end I did took the thermostat off (although it was a new after-market one) and compared it to the car's genuine one. I then decided to do a little test and boil both of them in bowl. The results were mind-blowing:
on the left it's the after-market Hella, and on the right the...
I used a vaccum device to bleed the system and brakes are great! I do still have the LSPV but I did some changes on the brake lines, see my first posts!
Sadly my Cruiser doesn't have the OBD 2 plug although it has the newer O2 sensor and airflow meter...
I did the gauge mod and it rises...
With the new set-up on the engine I took the Cruiser to a great LPG specialist and we spend a whole day fine tuning it. Now it runs better on LPG than it does on petrol! The LPG systems has been mapped for boost in order to make sure it won.t run lean again. After that I had some long drives...
With a new power plant in place, it was the time to do some brake overhaul also. So the story got repeated: new Aisin master cylinder, cleaned and painted calipers, new oem gaskets and new front brake pads from the 100 series. The difference was massive!
Time passes quickly and there went 2 years since my last post. I.ve been through a lot those 2 years and had little time to check-up the forum like I used to. Never the less, my cruiser did get some attention and did give me some big headaches (and still is!!) but I decided to catch up with you...
Today I installed a nice steering column bearing. I saw that several people said that the bearing was making noises when turning the wheel, I didn't want that to happen so I took some time to remove the small black panel that the bearing gets bolted on to study the problem. I saw that the...
Do you still have (if so, prices?):
From ABS sensors and cables?
Plastic case arround steering wheel column?
Genuine floor carpets?
rear right seat belt buckle?