Search results

  1. B

    SOLD Old Man EMU 2850J Springs (pair)

    Sorry -- sold.
  2. B

    SOLD  Old Man EMU 2850J Springs (pair)

    I have a pair of Old Man EMU 2850J springs with the factory box. Bought them about 6 months ago, and only drove the truck once since, but have now switched over to a Slee 4" Lift system. Southern California -- pickup would be best but can ship at buyer's expense. $100
  3. B

    Different 80 Models -- LUB vs. VXL

    As far as I know truck is from US (built in Japan). '97 Land Cruiser. with lift-up rear door. Tag actually says it is an FZJ80L-GNPEKA, though partsouq does not list that exact designation. Photo of tag attached.
  4. B

    Different 80 Models -- LUB vs. VXL

    I am in USA
  5. B

    Different 80 Models -- LUB vs. VXL

    Looking to buy some replacement parts, and Partsouq.com tells me (by VIN) that my '97 is a FZJ80G-GNPGK , but then in the parts listings page for that model there are two versions of some trim parts listed for '95-'98 vehicles -- one says LUB and one says VXL -- how do I know which is correct...
  6. B

    Wanted  Wanted: Whole Hog Woofer Mounting Bracket for '97 Land Cruiser

    Thank you. Sorry if got posted multiple times. My first classified.
  7. B

    Seriously delayed 1st-2nd shift in low range only

    I've been driving it offroad in 4WD for years, and it has never behaved like this. Thanks - Barry
  8. B

    Seriously delayed 1st-2nd shift in low range only

    Thanks for your help. Haven't gotten home to look at the FSM yet. So I'm not sure what the cause could be....
  9. B

    Seriously delayed 1st-2nd shift in low range only

    Definitely not normal -- actually went as high as 5K RPM. I have been driving this truck for >10 years and this is new.
  10. B

    Seriously delayed 1st-2nd shift in low range only

    '97 with pin 7 mod and CDL switch. Had it offroad last weekend, and when in low range the 1st-2nd shift sometimes didn't happen until 4K RPM. I had no time to dig into it this week so I had a local well-regarded transmission shop take a look. They confirmed the problem, but claim the...
  11. B

    For Sale  Ring and Pinion F&R sets from '97 80-series - OEM 4.11

    I upgraded my '97 80-series to 4.88 and have the factory 4.11 sets for sale. They appear to be in perfect condition -- vehicle had about 90K miles when they were removed, and was rarely used off-road. Toyota replacement 4.11 gears are extremely expensive, and I understand aftermarket is not...
  12. B

    What thermostat with supercharger - new info

    PCV Mod Never mind my request for an explanation...I found the PCV 101 thread. Bob Garner said they did it the way they did because they could just connect to the OEM fitting.....
  13. B

    What thermostat with supercharger - new info

    Future of superchargers I did get to communicate with Bob Garner again, and he said the future of the 80-series superchargers is unclear, due to low demand. As for the discussion about PCV routing, I am not sure I understand the issue, but he said that CruiserDan is the one to talk to. Can...
  14. B

    What thermostat with supercharger - new info

    I have followed all the threads here about cooling on 80-series with SC, and agreed that the 190 thermostat made sense, as the 160 TRD recommends would only delay overheating a bit, and the engine was designed to run at 190. BUT, I had a long talk this morning with Bob Garner, who is the...
  15. B

    Re-gearing causes ABS trouble?

    Thanks for straightening that out... I didn't believe them either, especially because they has no definitive reason. As to 4.56 with 33's, I just added a supercharger and that pleasant increase in performance made me remember the decrease when I went to 33's, so I have been tempted to get...
  16. B

    Re-gearing causes ABS trouble?

    I was just told by a well-known shop (TLC in the LA area) that I should not re-gear the differentials in my '97 LC (factory lockers) because it will screw up the ABS system. FIrst I have heard of this...are they right? Running 33's and was thinking about going to 4.56 Thanks
  17. B

    Rebuild Changes for Supercharger

    After the mysterious engine failure on our '97 , we bought a new short block from Toyota, and the mechanic is rebuilding the engine using the original top end. Since I intend to put a TRD supercharger on sometime soon, I was wondering if there were any changes recommended during the rebuild...
Top Bottom