Search results

  1. meps161091

    locker actuator rebuild

    Yer I think the windings have gone, so would need to be rewound, I would have a go at it. thinking about electric actuators currently, much like the air actuators that have already been developed. I need to do more research but I believe the only reason for the clocking and the complicated...
  2. meps161091

    locker actuator rebuild

    Fear you would say that! I will do some more experimenting before replacing With new or looking at air setups
  3. meps161091

    locker actuator rebuild

    Same here! Can we get any parts for these? My motor windings seem to be bad, smoking when I bench test it just now. I seem to have also messed up the plastic teeth in the large wheel. Motor cover that the magnets are housed inwould also be a good thing to replace on mine
  4. meps161091

    locker actuator rebuild

    My rear wasn’t engaging, opened it up today, what a mess! I will see what/if I can save anything. I think all but one bolt snapped straight off even after being left in oil, welding nuts onto the broken studs didn’t work either. Center punched and drilled out the best I could, will use a bolt...
  5. meps161091

    What happened to PFran of PFranleds?

    Same here, seems there are loads of posts on the issues people have had recently. I only ordered from him as its on the list here - Must have CHEAP mods to 100 Series Maybe that post should be achived or removed
  6. meps161091

    What happened to PFran of PFranleds?

    I ordered on the 23rd Nov, no confirmation email, says its still awaiting fullfilment on the orders page on the website....Paypal dispute here we come. Such a shame as everyone raved about Pfran
  7. meps161091

    New cruiser owner

    So defiantly not 400, I’ve just hit 180 for half a tank, so maybe around the 360mile mark. 21 gallon tank, so about 17mpg currently
  8. meps161091

    1HD-FTE fuel pump

    Yes, im starting to understand now the ticky sound might just be normal, i only have my dads 80 4.2 1hdt machanical pump for reference. Shaun who runs/part owns the company mentioned above, did say to check any of the rubber pipes going to the pump, as the pump is always sucking, IIRC he...
  9. meps161091

    1HD-FTE fuel pump

    Thanks, Just phoned him and spoke for 20mins, he was very reasuring, gave me a few points to explore and try, but reassured me these are noisey in their injection process by nature - and maybe it was the timing control value on the way out that made the pump so quiet, and now its working, its...
  10. meps161091

    Central Locking

    Here are some of my atempts and findings video recorded: https://sitecore.box.com/s/737bicqmf502gu4jmpxx9h3a3lp48047 https://sitecore.box.com/s/myx056slv6ghk21l7t1zdiq4twtmin14 https://sitecore.box.com/s/myx056slv6ghk21l7t1zdiq4twtmin14
  11. meps161091

    Central Locking

    So I tried that one too, when I have my drivers door and press the lock button, all doors lock then instantly unlock....I will get a video, brb
  12. meps161091

    New cruiser owner

    Bog standard currently Some service stuff done - fuel and air filter, new alternator and belts, oil & filter and timing belt next Sort some of the areas that need attention, then tyres, change the side steps for sliders, remove all the old AHC lines and res and then treat the frame, service...
  13. meps161091

    1HD-FTE fuel pump

    Thank you for the information, very informative! Where are you based, in the UK? How fast can Shaun recalibrate them? This is my daily drive, but I could do without it for a week. Currently im just monitoring the ticky noise from the pump, but dont want to damage anything in the engine
  14. meps161091

    Central Locking

    Hi all, Here is another central locking post....maybe with a difference So ive got 2 keys with remotes built in and a vallet key - only one of the key blades work in any of the barrels, so im using that currently. But would like to get either the other. key with remote reground or a new blade...
  15. meps161091

    1HD-FTE fuel pump

    Hi all, Recently brought a new to me landcruiser - im impressed with it! But last week it died on me, engine management light came on, no power. Quick google brought up the accelerator position sensor plug, on the top left of the engine, checked all the plugs, seemed fine, even did the wiggle...
  16. meps161091

    New cruiser owner

    Hi all, Signing up here to learn, document and post on my learnings for all to laugh, smirk and maybe find useful at some point in time. I have recently purchased a 100 series land cruiser, specs below: 2001, red, 4.2 1hd-fte 4 speed auto, VX model with cream leather and wood effect interior...
Top Bottom