Search results

  1. ryaneddy16

    Builds  Project UZJ60

    Better late than never. Did a SOA in high school and now need to fix dents and some rust and the suspension. Here is what I have done so far. 83 95 fzj80 chassis with 3in dobison springs 2uzVVTI H151f and a 80 series tcase
  2. ryaneddy16

    For Sale  LC R151f WITH split case

    I was sold the wrong trans and now trying to recoup and get what I need. I have a R151f that came off a 1hz was told it has been rebuilt with 3000km on it. It comes with a 38mm split case from a fj62 that had 170000 miles. Looking for $1500 US OR trade for a h151f transmission. Located in COlorado
  3. ryaneddy16

    Wanted  Fj60 body

    ISO rust free 60 body preferably pre 85 but will take what I can get. I just need a shell. Dosen't have to have a dash or Hvac. Open to buying a parts truck. Located in Fort Collins Colorado
  4. ryaneddy16

    A340 trans controller

    So I'm putting a 1uz and a340 from a 92 sc400 in my 99 5lug 2wd taco. I'm wanting to run my stand alone ecu and so I was looking into using a tcm for a Aw4 to control my trans since there essentially the same. Has anyone done this before with scusess? I've red conflicting information.
  5. ryaneddy16

    For Sale  fzj 80 rear axle

    Selling a FZJ80 rear axle out of a 95 with about 190,000miles asking $300 OBO located in Houston Texas
  6. ryaneddy16

    For Sale  fj60 gas tank (replaced under recall)

    selling a gas tank out of my 83 fj60 had it replaced under recall 7 years ago. asking $250 OBO located in Houston Texas
  7. ryaneddy16

    For Sale  HFS 2.5in lift kit 60/62 Houston TX

    selling a used HFS 2.5in lift kit for a fj60 or a 62 bushings are good in the springs comes with shakes and ubolts (not pictured) $750 OBO
  8. ryaneddy16

    For Sale  3fe Fuel injection TX

    I have everything you would need to put a 3fe head and fuel injection on a 2f short block. Everything from the head all the way down to the harness and ecu. All parts came off of a running fj62 Asking $800 can take more pics upon request
  9. ryaneddy16

    For Sale  FJ62 axle housing TX

    Front axle housing from 89 FJ62 $250 OBO you pickup
  10. ryaneddy16

    Parting Out  83 Fj60 Rolling chassis TX

    Selling everything from the drivetrain to the axles. Everything from the rolling chassis is going. Im keeping the body. running 2f head rebuilt about 9 years ago, runs strong, has over 200,000 miles on it $600 for long block $750 with accessories 85 T-Case need rebuilt $300 rear Axle...
  11. ryaneddy16

    For Sale  M416/M100 Bantam style trailer bed kits

    So I have been hashing out the details and now they are ready. For those looking to get into an "overland" style trailer, I may have your solution. For those home builder types, I am offering M416/M100 Bantam style trailer bed kits in both mild 12ga and 10ga steel as well as 12ga 3003 aluminum...
  12. ryaneddy16

    For Sale  M416/M100 Bantam style trailer bed kits

    So I have been hashing out the details and now they are ready. For those looking to get into an "overland" style trailer, I may have your solution. For those home builder types, I am offering M416/M100 Bantam style trailer bed kits in both mild 12ga and 10ga steel as well as 12ga 3003 aluminum...
  13. ryaneddy16

    Wanted  Fj60 Drive shaft

    Looking for a D.C. front Drive shaft out of a pre 85 fj60. Located in Colorado
  14. ryaneddy16

    Wanted  cable lock axle shaft

    Im looking for a front long side axle shaft from a HJ60 or a Cable locked axle. PM preferred but will check in here as well.
  15. ryaneddy16

    How bad is it really

    Well its sad but i think my motor is toast. I found this in the oil pant when i pulled it to change the gasket. Its all metal. My motor docent knock but has had low oil pressure and low compression in one cylinder. I have a thread on here talking about what i wanted to do if I swap the engine...
  16. ryaneddy16

    For Sale  2FE parts and 62 parts

    Selling all the parts to do a 2FE. All parts came out of a running 88 FJ62 -3fe head with everything attached to it -complete intake with air filter housing -fuel injection lines -FJ62 distributor -fj62 tank -harness -computer -a 2f only thing missing is push rod cover (over 200,000 miles) If...
  17. ryaneddy16

    swap dilemma

    Well im in a dilemma. My Original plan wa to do a 2fe swap in my fj60. Have all the parts ( had a fj62) My plan was to rebuild th bottom end ( have a spare 2f) And do everything i could do (balance rotating assembly, port and polish, headers, rv cam, SBC valves) Then get a H55F and the 4to1...
  18. ryaneddy16

    For Sale  1987 xtra cab 4x4 trade for 2wd

    just wondering if anyone would be interested in trading my 4x4 xtra cab for a 2wd toyota pickup or buy it $1300 1987 3xx,xxx miles Rebuilt motor The bad needs flasher exhaust leak at head rear main leak needs windshield seat torn rust (cab just has surface rust on roof) This is my daily driver...
  19. ryaneddy16

    om617/606 questions

    im looking to swap either a om617 or a 606 in to a vehicle and had some questions. I want a lot of power idealy 500hp but be happy with 350-400hp. OM606 What dose it take to swap it? Hrness and computer? Can you put a mechanical injection pump (603 pump?) Dooing this would i avoid the...
  20. ryaneddy16

    August meeting

    This meeting will be on the 27th. Where are we going to have it guys???
Top Bottom