Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Yes, all 4 door are components. Yes woofers. Cool they have a 30 degree pod thatpushes the high towards center of truckThat’s a brilliant use of space, well done—looks like crossovers for all four doors? By mids, you mean woofers? Morel makes a 3 way as well. Very cool location for rear tweets.
How do you like that Planted seat base? How easy was/is it to adapt your new selection of seats? I am thinking of replacing my fronts for some WRX seat and was looking at the Planted seat base.head unit in........mock up on the console.....next up is pull the switch out and wire to the pre-wired relay box.
View attachment 3027379
View attachment 3027380
View attachment 3027381
seems very well made, pricey for what it is but thats the way it is. I would think this is an easy adaption process to mate to a variety of seat base footprints. Given the amount of surface area there is to work with, i'd bet you will only need holes drilled to mount the Subaru seats, for the most part, they are all with an inch or two..How do you like that Planted seat base? How easy was/is it to adapt your new selection of seats? I am thinking of replacing my fronts for some WRX seat and was looking at the Planted seat base.
Where did you get the gasket material for the gutters and also the caps for the hold down bolt ends? Never mind I found it further in your thread.So first up is a Prinsu Roof Rack, simple and clean. 3/4" space between the factory roof ribs. Very nice powder coating and a good tight fit. The gutter hardware is a bit light duty for my taste, but I havent seen a rtt on the side of the highway ...yet.
I went ahead and bought a roll of gasket material for the base of the rail to protect the gutters and reduce any shift or noise associated with metal on metal.
The oem roof rack holes will be filled with bonded washers, silicone and stainless bolts.
View attachment 2819644
View attachment 2819645
View attachment 2819646
View attachment 2819647
That is a pretty amazing solution. Nice work. Hard to tell with picture sequence—are the three bolts exposed at finish?run your wiring up to the newly drilled hole and BOOM....screw in the 3 supplied bolts and enjoy
View attachment 3037537
View attachment 3037538
Not enough for me to noticeThat is a pretty amazing solution. Nice work. Hard to tell with picture sequence—are the three bolts exposed at finish?