If you could pull one out and take some accurate measurements, I could make you one.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Still working on the 80...
So had to pull the upper plenum back off just before I torqued the new gaskets down due to a bad thread in one of the holes. Any how, one of the rear alignment bushing/spacers feel down into the frame area never to be seen again.
It appears it comes with the plenum and is pressed in.
Has anyone else encountered this and found a good replacement part?
This pic was borrowed from mud but the red circle is the bushing/spacer I looking to replace.View attachment 2579864
Thanks. I'll pull one tomorrow.If you could pull one out and take some accurate measurements, I could make you one.
For those of yuse guys on the Charlotte Metro area, and beyond if you dont mind shipping, this is the link to Hendricks Toyota Online Parts order. I have been consistent looking at 30% lower than phone or other dealer parts for pickup at store. Even a few parts that I have seen "hard to find" , they seem to get them in 1-2 days for pick up.
How does that compare with McGeorge in Richmond?For those of yuse guys on the Charlotte Metro area, and beyond if you dont mind shipping, this is the link to Hendricks Toyota Online Parts order. I have been consistent looking at 30% lower than phone or other dealer parts for pickup at store. Even a few parts that I have seen "hard to find" , they seem to get them in 1-2 days for pick up.
So that’s why that piggie is smiling!Max will be getting the same drive line as Mary above so we'll be doing the motor mounts and cross member right after Mary
Mary's cross member
It's never a simple job on these old vehicles. You got off real lucky on no seized hardware.Well a test to see if the penetrating oil was working kinda spiraled. Got really lucky and didn’t break any studs. View attachment 2593388
I’ve been meaning to grab some Kroil, I soaked these for a couple of days in pb blaster since I had it on hand.It's never a simple job on these old vehicles. You got off real lucky on no seized hardware.
If you haven't already got some Kroil Penetrating Oil get some, it's the bomb for these old Landcruisers.
I bought them already painted with VHT paint.Did you paint it or did you yet coated?