- Joined
- Jun 6, 2005
- Threads
- 63
- Messages
- 1,185
- Location
- Jacksonville Beach, Florida
- Website
- exitoffroad.com
- Thread starter
- #21
3 degrees of caster. Standard alignment cams from memory have plus/minus 2 degrees of adjustment, so they would have to take away caster from the cams to set it right. It can probably be done, as long as the tech knows what he is doing.how much built in caster do the uca's have? and can they be installed on an unlifted truck in preparation for a lift down the road? are the 555 joints the same ones that would be used in a stock uca so we can maintain them in the future?
also where are the uca's made?
i don't know enough about alignments but was concerned your uca's might have too much caster when not lifting the truck.
Yes the ball joints are the same that would replace the OE. The ball joints are made in Japan and the arms are made in China