Hi guys
Been doing a lot of reading and research about the pro's and con's off splits and made a decision to put a set of 8.25r16 Haulmax ATT304s onto the original 40 series split rims with hubcaps.
(Found this to be a great article)
I've been having bit of a hard time finding info regarding the inner tubes people purchase/buy
I usually run low pressures (down to 12psi) and in the past i've had problems where the (cheaper Chinese made) inner tube would pinch and develop a slow leak.
I heard that there are better options with much thicker inner tube - can someone please point me in the right direction where i can find more info or better yet suggest where i can purchase the thicker tubes for the 8.25R16 tyres (which could pose a problem as most would sell the 7.5R16 size)?
I don't mind paying that little bit extra now to avoid the problem of flat tubes and repairs later that could have been avoided.
Also, i've read that the valve stem is another interesting topic that requires some knowledge
I'm i right to assume that i need a TR75A tube that is off-centre for the stock 40s rims?
If i've missed some links, please post them below
TIA
Been doing a lot of reading and research about the pro's and con's off splits and made a decision to put a set of 8.25r16 Haulmax ATT304s onto the original 40 series split rims with hubcaps.
(Found this to be a great article)
I've been having bit of a hard time finding info regarding the inner tubes people purchase/buy
I usually run low pressures (down to 12psi) and in the past i've had problems where the (cheaper Chinese made) inner tube would pinch and develop a slow leak.
I heard that there are better options with much thicker inner tube - can someone please point me in the right direction where i can find more info or better yet suggest where i can purchase the thicker tubes for the 8.25R16 tyres (which could pose a problem as most would sell the 7.5R16 size)?
I don't mind paying that little bit extra now to avoid the problem of flat tubes and repairs later that could have been avoided.
Also, i've read that the valve stem is another interesting topic that requires some knowledge
I'm i right to assume that i need a TR75A tube that is off-centre for the stock 40s rims?
If i've missed some links, please post them below
TIA