2015 LC leans + 1" down on the left (drivers)side measured at both the front & rear wheel wells. Loosened screws 3 turns then backed up on a chunk of 4X4 under right rear tire(high side). Tightened screws and then drove off wood. No change. BTW, KDSS screws were tight, but no rust.
Tried another recommendation - did the KDSS 3 turn drill , but this time stood on the side steps and rocked the truck as much as I could. Tightened screws -0- change.
Thought about loosening the screws 3 turns and going for a short drive and re-tighten screws....have not done that.
Any other suggestions?
THX!
Tried another recommendation - did the KDSS 3 turn drill , but this time stood on the side steps and rocked the truck as much as I could. Tightened screws -0- change.
Thought about loosening the screws 3 turns and going for a short drive and re-tighten screws....have not done that.
Any other suggestions?
THX!
Last edited: