Printed circuit connector? (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 31, 2015
Threads
44
Messages
144
Location
MT PLEASANT SC
What is the best way to put the printed circuit connector on a new harness.Are new terminals available? I have the housing. I didn't see them on coolermans site.Thanks, Tommy
 
Thanks,but I'm just looking for the terminals. Even with that kit you would still have to splice it into your existing harness.
If just the terminals are not available what do you do to connect a new harness. I can cut the wires on the old harness at the connector and slice it into the new harness if that is what I have to do,it just would be neater(and correct) to have new terminal ends.
 
I am pretty sure mark reuses the plastic connector

Odd that the connector that’s on eBay is white...most likely 3d printed I assume
I will reuse my old plastic housing,I just wanted new terminal ends . I hope I'm using the right terminology.
 
I will reuse my old plastic housing,I just wanted new terminal ends . I hope I'm using the right terminology.
Did you find the OEM Yazaki terminals for your old connector?

78638FE4-A8DC-4C0D-B41D-DEABB9798F41.jpeg

DADB1DAC-770F-451C-BE90-AD0BB187CD0F.jpeg

3B611A4A-3F37-4BB6-9F6A-28B3D2A0B137.jpeg
 

Users who are viewing this thread

Back
Top Bottom