Not sure what OME springs I have (1 Viewer)

[bubbaZR2]

I bought my 80 a while back and I'm not sure what springs I have. I know they are OME springs, but I am not sure which ones they are. Its running 315/75/16s and sits 2" higher in the rear. I am hoping to lower the rear to get rid of the stink bug stance. Any one have any ideas?

 

[GW Nugget]

How many turns do the coils have?

 

[bubbaZR2]

Looks to be 8 turns.

 

[decoco]

I like stink bug, leave as is, or get spacers up front if you're not adding weight up front.
I know that's not what you asked, /sincerely, unsolicited opinion

 

[GW Nugget]

I see a white tag on the coil, look on top of it with a mirror. It's hard to count from that picture. Start your count at the bottom.


OME specs
http://www.arbusa.com/Uploads/PDF/onlineManualsGuides/OME_Guide_current.pdf
Rear

860 = 6.88 turns
863 = 7 turns
863J = 7.7 turns
Front


851 16mm/.629" 8.18 turns
850 16.5mm/.649" 9 turns
850J 17mm/.669" 9.9 turns

 

[GW Nugget]

What is your center of hub to bottom of flare measurement? 20" ish is stock height.

 

[bubbaZR2]

I'm an idiot. I didn't notice the white tag. It says "OME860." The rear hub to flare measures at 24" and the front is 22". Now I'm really confused. How would an 860 cause the rear to be so high? What spring should I use to lower the rear 1-2 inches?

 

[GW Nugget]

An 860 should not give you 4" of lift, 3" at most.
Put some 30mm spacers on the front & add weight to the back. Those 860s will go down fast with weight.