Anybody know the rear pinion flange bolt patter for a 97? I measured 3.55 inches (90mm) square but that is way too big based on wha i can find online. The front seems to be right at 60mm square. Any help?
Pinion flange bolt pattern (1 Viewer)
- Thread starter hammerheadfistpunch
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
It looks like 2.55 inches, not 3.55.
Quick check on a spare driveshaft this morning. Kind of an eyeball caliper job but really close.
Quick check on a spare driveshaft this morning. Kind of an eyeball caliper job but really close.
My guess is that my eyeball job is off a smidge making the centers 65mm. I can't imagine the dimension going into decimal places from there. It is a square pattern too, which you probably already know. Hope it helps.
66mmx66mmx11mm holes
jfz80
Cruisin’
Edge to edge distance will be the same as ctr to ctr..... just sayin, a lot easier to eyeball that way
Or use Kurts cheat sheet
66x66x11
Cruiser Outfitters
Which doesnt quite cover 80s but his catalogue has some clues
Or use Kurts cheat sheet
66x66x11
Cruiser Outfitters
Which doesnt quite cover 80s but his catalogue has some clues
Good point. Don't judge, I hadn't even had coffee at that point.Edge to edge distance will be the same as ctr to ctr..... just sayin, a lot easier to eyeball that way
Or use Kurts cheat sheet
66x66x11
Cruiser Outfitters
Which doesnt quite cover 80s but his catalogue has some clues
View attachment 1542354
- Thread starter
- #7
Thanks to all!
