just curious about the ballpark on what a complete clutch job would cost.
Anyone have ideas?
Thanks
Anyone have ideas?
Thanks
General price of clutch installed (1 Viewer)
- Thread starter 4david
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Using OEM/Aisin clutch disk, pressure plate, throwout bearing, and pilot bearing.....parts cost is around $250-350 depending on parts source...not including flywheel (normally just needs resurfaced and stepped). If you have a shop do it, the transmission has to be pulled so labor will be some $$.
- Joined
- Jun 21, 2011
- Threads
- 225
- Messages
- 20,966
- Location
- Redding, California
- Website
- trail-tailor.com
AISIN CKT032 Complete Clutch Kit from RockAuto--- 144.79
Ballpark labor is 500-1200.00 pending shop rate and if they go off a standard shop scale rate per job detail or experienced actual replacement time from smaller shops. My guy at Toyota did mine for 600.00 and I supplied the above clutch kit, a resurfaced flywheel and the oil pan gasket and RMS since it was opened up.
J
Ballpark labor is 500-1200.00 pending shop rate and if they go off a standard shop scale rate per job detail or experienced actual replacement time from smaller shops. My guy at Toyota did mine for 600.00 and I supplied the above clutch kit, a resurfaced flywheel and the oil pan gasket and RMS since it was opened up.
J
There ya go, even better!
Buy the Aisin kit above, get a Habor Freight transmission jack, blind bearing puller and do it yourself...if you have the time and room. That is what I did.
As stated above, might want to change the oil pan gasket. Definitely replace the rear main seal (RMS) and get flywheel resurfaced.
As stated above, price to have a shop do it would be $700 to $1200.
As stated above, might want to change the oil pan gasket. Definitely replace the rear main seal (RMS) and get flywheel resurfaced.
As stated above, price to have a shop do it would be $700 to $1200.
