I just did this job last week...had what I thought was bearing play, but found out last guy in there assembled the hub lock nuts/washers wrong...allowing the lock nuts to loosen consequently allowing too much freeplay. I was replacing rotors/pads/seals/ calipers so I removed bearings & cleaned...
electrical problem
I finally have time to get back to work on it today... I'll check the relay circuit 1st. I had actually tested/replaced the relay but failed to check the circuit itself. thanks for the advice! I'll post the outcome.
abs sensor
it is most likely the right front ABS sensor. the light comes on when a problem is detected. it resets itself on obd1 systems when you shut down the ignition. there are trouble codes you can read before shutting off ign. they are published in the repair manual. It involves using...
I'm looking for a drivers leather seat for a 97 4runner, beige. any ideas who to call?
P.S. I may be new to this site but I've owned 5 4runners, 1 tundra, 94 4wd v6 p/u, 96 tlc. next one will be fj cruiser.
blows all H/L bulbs (4) when brights turned on. testing shows 12v current on to low beams even when switch is off, has current (12V) on both leads to high beam bulb when switch is turned to bright or flash. I tested/replaced H/L relay, no effect. I tested continuity of dimmer & combi...