Had these wheels on my 200 for about 4000 miles. Wife recently took over my LC and she hates gold rims. I switched over to a set of Black FN Wheels, Dustin makes some great rims.
I'll believe the offset is 25mm, I ran 285/75 - 17's with a tad bit of melting on the front inner fender, slight rub...
At the time I was running OME 3". Also talked to Cristo about the relocation bracket and he felt it wasn't needed. Removed the front mud flaps and needed to melt the front inner fenders, proper alingment with the SPC's helped to not have to do any body trimming.
I do have a lift standard fair OME with SPC uppers. To clear the 285/75 17's I had to remove the front mud flaps and trim/melt the inner fender at the front behind the bumper.
I do still hit the KDSS bar on the drivers front. May be able to fix that by bringing the caster back a bit with SPC's.
Specs are as follows:
17"x8.5" - 5 on 150, 5.75" backspace, 25mm offset
I actually have these up for sale. Doing some testing and modeling of new rims for a local vendor. Theses Icons have been great wheels, if I wasn't trying to help a buddy out I would leave them on.
When I was running 285/70's no rubbing at all. With 285/75's there was a tad bit of rubbing on the front plastics, I had to melt a little to clear.
Also the 285/75's do hit the KDSS bar on the drivers right side. But I just installed SPC upper control arms and plan to adjust the caster...
I used the industrial Super Glue that is supposed to be vibration resistant. It's holding up great, the are very solid.
In regards to stregth, I assume you mean the wheels themselves? If so they are performing as expected, the finish on the rims is pretty tough.
There is a scuff on one of the...
Hi gents,
Going to be modeling some new rims for a local vendor so I'm putting up my Icon's up for sale.
I have 5 rims total (full size 285/75-17 fits in factory spare location)
Rims have a bit less that 4000 miles on them and are in great shape.
Tires and TPM's are NOT included.
Asking...