Recent content by toyofj60

I ordered a full led kit for my 80 series from fully lit led awhile back , my parking lights have recently both quit working and i would lights to order aome new bulbs but i am having trouble finding the company ....im pretty sure i sent an email to the owner requesting the kit i wanted when i...

Outer banks NC with the fam

Try again

Brand new 315/75/16 just barely touches the panhard rod no pressure up against it, it is rubbing the paint off the rod is about the only problem ive noticed

Here is what mine looks like with 315 underneath and hitch modified to fit

U still have these ....pm me

Btw in the past couple weeks ive added pfran full led kit , ome med 2.5 lift, and 315/75/16 general grabber at2

Today .....installed cdl switch, did 7 pin mod, tied dome lights together via kickpanel connector jumper so both come on when any door is opened, also installed the AJIK spare tire lift tucking my 315 up under pretty nicely.....altho i did have to remove my hitch receiver for it to work out So...

Also the brackets can be used to move the crossmember closer to the rear of the cruiser allowing a taller tire to fit without touching the panhard rod

Bryson is correct the slots in the frame brackets can be used to raise the crossmember another inch or so....only if you have a body lift , without a body lift u dont have any room to move up any higher ......its easier to understand if u get under ur lc and look

Installed this kit tonight with brand new 315/75/16 tire and it raised crossmember about 2in and leveled out the tire .....it looks like the tire is hanging about the same height as it did with the factory spare but its level and not angled down in the front

I dont like stick on weights..... In the past ive ised them and eveytime i go in deep sand or mud they start falling off

They know what their doing....the tires have a rim protector and the factory FZJ wheels have a thick lip thas why the clip ons wont stay on

I have recently gotten a set of 315/75/16 general grabber at2 tires on my lx450.....when they were installed the tire shop tryd balancing with clip on weights. It drove great for a few miles then weights started flying off left and right ......so i went bake to tire shop and got them to order me...

Yea same springs i got...slee says its 2.5 in front 3 in back