Recent content by tom warner

For the precut foam pieces, try Parts puzzle, ( ebay). their kit is a bit pricy but excellent pieces and foam. saves lots of time

hey thanks, I;ll look, t

yeah dont know why this would not work. thanks. tom

thanks, sounds like it might be a plan.

hey thanks a bunch, I cannt get a direct connection with the other web site, maybe this one has a local mail.? thank a bunch , what a pain to get these parts. tp,

thanks mucho, apprecaite the web site, unfortunately they will not send to the USA but its good to know, I am wondering if I can hone an after market ones downto fit ? thanks again

I know this is a very date thread but if anyone has any info, where can I find replacement brushes for the heater blower motor? and is thater a best way ( other than patienc) to re-intall the brushes and assemble the motor housing? If anybody is out there that might know?

I hear you buddy, .. Thats too bad and there is not much you can do. I know how it goes down south, I lived in El Paso, 3 blocks from the border,my whole life IT is too bad that car painting in the US is so over regulated to the point of making it finantially impossible to get a professional...

I am in SD ,can you send me the name and address of this painter? tagkwarner@aol.com thanks,

here are the two, now, I am assuming that these are the correct ones, when I took a part my 78, I packaged these with the interior heater, As far as I can remember they did not leak, but one has kind of a ragged end. I just wish I could find the rear heater too. not sure where it is or what...

thanks, it might melt? not good. this is a lot of tedious work to melt down afterward, thanks so much,

ok Ryan, Ishould get you aphoto to make sure that you may still want it wo the insulation? send me a complete address. I dont actually know why I have these two pipes, because both the cruisers I have owned, had a rear heater? not sure why I ended up with these,. I actuallly looking for two...

please supply name of source of the 13 mm foam insulation for the pipes. thanks

can you supply the source of the foam insulation you used?

i have the two pipes but the insulationis rather worn, I cannt seem to locate a replacemtn pipe insulation> any ideeas? let me know if you want tje two pipes,