IH8MUD Community,
Recently I have started searching for an FJ60. I am in need of a second vehicle and am about to start a complete rebuild of my FJ40. Have always wanted a 60 as well and now have the need.
minimal body rust and a drivetrain in good condition. Unfortunately my 40 has...
I didn't know about cruisercorp. I'll drop them a line next week. My rig right now is in OKC so that could work.
My understanding is that CCOT no longer rebuilds customer rigs. I sent them a note an hour ago. They would be might starting point if they were able to take it on.
Forum,
Recently I had to ship my '78 FJ40 from California to Oklahoma. I live in an apartment in San Francisco and had no where to work on the beast and is was falling into disrepair. Its time to do a full down-to-frame rebuild and am looking for the best shop in texas or oklahoma. Are there...
I will check on the transfer case. I have always had an issue with a lubricant leak between the transmission and the transfer case. I may have lost some oil in the last couple months.
Thanks for the help
Not an issue with controlling speed. At 55 mph it feels and sounds as though I am in 3rd gear. Very loud, burning through gas, high temps due the to the high RPM. When at idle if I apply full throttle she sounds fine.
An interesting thought on the linkage. I will take another look to see...
I almost have my '78 running smoothly. Recently installed a re-built carb. Adjusted the idle to get right at 650 rpm. Have yet to adjust the fast idle, so the choke works but will die if I pull it all the way out.
My problem is that it runs at super high RPMs at highway speeds >40 mph in...
Sounds about right. I was pretty careful to achieve the 9MM/1MM clearance with the float but I obviously didn't get it right since there is no fuel visible in the sight glass.
Ih8mud members,
I am having a lot of trouble recently with my 40. As a back story, a few months ago I was having trouble with my fuel filter constantly getting clogged from some sediment or rust in my gas tank. I replaced the filter and flushed the gas tank, but I was having issues with...
Ok, the "cup" labeled 19 I can get from SOR. For some reason I don't believe I have one, but I will verify this next weekend when I get the thing properly disassembled. But the second spacer outlined in red i do not see on any diagrams from Cool cruisers or MAF.
IH8mud community,
I few years ago I had a crappy repair shop repair my center arm since I could not for the life of me get it disassembled.
I was looking at it again and decided that I needed to disassemble it again - double check that it was repaired correctly (there is just something not...