suprarx7nut's latest activity

  • suprarx7nut
    suprarx7nut reacted to xswl's post in the thread Key Fob Case with Like Like.
    There's a limited run of UZJ100 printed key fobs going on right now which saves $5 if you preorder: UZJ100 LIMITED RUN! - YMD1 - Titanium Reinforced Toyota/Lexus Key Kit -...
  • suprarx7nut
    plan to relieve all the pressure/fluid I can, install, bleed. Seems pretty straight forward. Baselined my system got front cross leveled and pressure in check - plan to do a small (~3/4") sensor lift, crank T bars 30MM spacer in rear and...
  • suprarx7nut
    suprarx7nut reacted to Moderator's post in the thread replacing AHC globes/accumulators with Like Like.
    If I can't get it fixed this weekend I'll shoot you a pm next week. I get off shortly after lunch sometimes on Fridays so might be heading that way next week.
  • suprarx7nut
    An XJ and a 100 series are a world apart. A low mile, clean 100 is a $60-70k vehicle right now. Values are increasing. Likely bottomed out 2-4 years ago. As more time goes on it becomes clearer and cleared that few vehicles are built like a Land...
  • suprarx7nut
    suprarx7nut replied to the thread Key Fob Case.
    I'm not sure how those are supposed to work, but if you feel like an upgrade, I know a guy...
  • suprarx7nut
    I just did our first AHC Evaluation service at our Air Down Gear Up shop in Frederick/Erie, CO today. I'd be happy to take a look. We charge a minimal evaluation fee and then typical specialist labor rates if we find something we can act on...
  • suprarx7nut
    Wiring diagram screenshots for those that like the pictures. :)
    • 1627009556569.png
    • 1627009625102.png
  • suprarx7nut
    I was able to take a look at this vehicle today in the Air Down Gear Up shop. Here's the scoop as far as we know right now. 1. AHC off blinking constantly. Car physically sits in a roughly regular N height and N light is lit solid. 2. Two...
  • suprarx7nut
    suprarx7nut reacted to dchilds's post in the thread Question for the audio gurus with Like Like.
    I managed to snag those pre-amp inputs and ran the signals over to the area I intend to install my line output converter and amp. One step closer! Thanks for the pointers so far
  • suprarx7nut
    suprarx7nut replied to the thread Question for the audio gurus.
    Because the purpose of this exercise is to avoid as much "flavor" (IE processing) that the ML system adds as we can. The ML amp is where the tweaking is likely to occur and we don't want that if we can avoid it. Low-pass signal into amp - not...
  • suprarx7nut
    Very cool. Suuuuper clean.
  • suprarx7nut
    suprarx7nut reacted to ramangain's post in the thread Question for the audio gurus with Like Like.
    ^^^^^ Noted, and thank you as I speculated all three front drivers get split from a single pair of wires. I stand corrected, but too lazy to find and fix my speculative posts from the past. KISS theory will always hold when mucking around with...
  • suprarx7nut
    I appreciate all the help and resources. I have one on the way as we speak. @ramangain I appreciate the offer. Im actually driving it down to VA to Virginia Beach tomorrow night for a week long vacation. If I was passing through the area, I'd...
  • suprarx7nut
    Dallas Custom Steering Wheel. Donald Le. Dude's a badass. He did my Supra wheel and my current LX wheel. Exceptional customer service and craftsmanship. Not cheap, but he's the best in the biz, far as I'm concerned.
    • 1626910626305.png
  • suprarx7nut
    suprarx7nut replied to the thread Question for the audio gurus.
    Here's my 06 Wiring Diagram situation. Can't guarantee it's the same for you. Rears may or may not be full range. I'd go for the signal coming *into* the amplifier. Trick there is to not to disturb the incoming signal to the amp as you still need...
    • 1626909727730.png
    • 1626909866956.png
    • 1626910353516.png
    • 1626910386328.png
  • suprarx7nut
    suprarx7nut replied to the thread Question for the audio gurus.
    I feel like the devil on one shoulder with you on the other side, haha.
  • suprarx7nut
    suprarx7nut reacted to dchilds's post in the thread Question for the audio gurus with Like Like.
    what I’m seeing elsewhere is:
  • suprarx7nut
    suprarx7nut replied to the thread Question for the audio gurus.
    Because the full range signal is most likely to be "flat". I haven't measured the ML system at all, but I suspect the sub signals are more tweaked than a simple low pass, or even bandpass. It's all speculation, but I expect in a premium system...
  • suprarx7nut
    suprarx7nut reacted to OwnerCS's post in the thread OME vs ironMan4x4 suspension kit with Wow Wow.
    I agree.. 100s do have a short turning radius with good approach and departure angles. FWIW - I went with 285/75/16 tires and SCS F5 wheels. The main reason was I learned from putting oversized tires on my Tacoma and lost my ability to climb...
  • suprarx7nut
    I suspect we're staring at a previous owner's improper attempt to disable AHC. :facepalm: Get that relay (tons of folks on the UZJ100 facebook group or here might have one remaining after they removed AHC) and then let's see what she does!
  • suprarx7nut
    Nothing will work without the relay. The power to the ahc pump motor goes through that relay. Directly from the 50 A ahc fuse, through the relay to the motor.
  • suprarx7nut
    With my Bluedrive OBII, it will state "5 max date points recommended" But I do 7 or 8. It may give some false readings in logs, but I can spot those. I can also switch in & out of other data points on the fly. It will than keep date of each...
  • suprarx7nut
    I'll throw in my $.02 as I have a bit of experience in other platforms and off roading in the rocks and mountains of Montana, but I'm rather new to the 100 Series as you are. My last 4x4 was a 2005 Nissan Frontier, which was a great rig...
  • suprarx7nut
    suprarx7nut replied to the thread Question for the audio gurus.
    If I were adding a sub, I would make sure to grab a full range signal. That said, @VagabondJesse is totally right - all depends on your expectations and how much work/$ is saved by just using the existing sub line. I'm sure it won't sound bad...
  • suprarx7nut
    suprarx7nut reacted to VagabondJesse's post in the thread Question for the audio gurus with Like Like.
    I would start simple, and then make changes if you feel they're necessary. If the amp already has high-level inputs, I don't see what value a line output converter brings. I'd say throw the sub in there, and if you like how it sounds you're all...
Top Bottom