Fairly easy way to check temp gauge calibrations:
You can pull the temp sender out of the engine and put in in a pop can or small coffee can with water or oil. Put a known good thermometer in the bath and heat the can with a torch.
You can then...
Its the same here in Western NY State. I don't hate Wanglers. But man I don't get it. There are are a :poop:ton Rubicuns around here that are seriously decked out.
Nobody under the age of 40 outside of this forum or outside of the Yotaverse has a "pherking" clue.
The 1st "40" I ran across was back off the paved road a fer piece. I was in a Bronco 1/2 cab with a 3 speed on the tree. I'm not sure who was...
I have noted, this year it seems more prevalent, that when I am driving my FJ40's the Jp folks tend to shoot me the Jp wave more often than not.
1. Is it because they don't know what a Jp looks like and mistakenly wave?
2. Or this because they...
I am about ready to plunk down the $225 needed for a year long membership at Famous Reading Outdoors. Their main location is about ten miles from my house. I had an annual membership a few years ago, hardly used it, and let it lapse. Frankly the...
Pull the shaft out completely and throw it away. Get yourself a collapsing shaft from a Land Cruiser specialist like Man-A-Fre that can sell you exactly what you need.
Call Rick at 702-568-1511
Buy one. It's not cheap. If you are cheap stop reading now and go see what's up in chat. :lol:
I just fitted my Wholesale Automatics Nomad valve body for the A442F. I got it through Cruiser Brothers/Valley hybrids. Georg looked after ordering...
My wife is constantly telling me to stop acting like a 15 year old.
I hope when I'm 90 and in the garage yelling at an old FJ she is still telling me this. Younger mans project my a$$!
I agree with @tornadoalleycruiser
Nothing wrong with the...
You need to completely redo your steering. Your current setup is an accident waiting to happen. How someone thought that rag joint to double d connection was acceptable is scary. Cut off the rag joint, install a column bushing, get a collapsible...
How about some pics of the steering box as well. Maybe the entire system?
I am not an expert but I can tell you that I believe the rag joint should be in parallel with the steer shaft where it can be supported on both sides. NOT used as a...
Yes, you got it. What year 40 do you have and was the bearing not installed or its just worn?
I assume this is a Saginaw type installation?
Show us more pics.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.