Recent content by srafj40

  1. srafj40

    Check out these sick bikes

    OK... I looked deeper. I have not seen a philwood hub in decades. LOVE!
  2. srafj40

    Check out these sick bikes

    The lost art of brazing...beautiful lugs...like the Italians used to do.
  3. srafj40

    Questions about a 2f rebuild

    Oil pump went and froze #1, and partial #2 and #3. Some oil was still going to #4,5,6.
  4. srafj40

    Questions about a 2f rebuild

    Bearings, pistons/arms, rings, oil pump, timing gears, cam, lifters, gaskets. Nothing to do with the top end valve, rods etc... 2F Master Engine Rebuild Kit-'75-'84 [NA-7584] : Cruiser Solutions, custom cruisers, restorations, genuine Toyota parts, body tubs, used Land Cruisers for sale
  5. srafj40

    Questions about a 2f rebuild

    Just rebuilt mine and used the Cruiser Solutions Master rebuild kit $1500 or so. The biggest thing I learned is that there is a 24mm expansion plug in the oil circuit that goes on the front of the block. The shop that bored, honed, and cleaned my block asked, "want us to put the plugs in?"...
  6. srafj40

    wiring

    I put mine upside down where the original block was.
  7. srafj40

    What have you done to your Land Cruiser this week?

    https://forum.ih8mud.com/40-55-series-tech/262629-help-quick-please-24-mm-expansilon-plug.html Then found the a short for the lighting system on the new wiring harness, dang old wires going to the right turn signal.
  8. srafj40

    Help quick please 24 mm expansilon plug ?

    Thanks, in a hurry and did not search. From the title that sounds like what happened to my new (son of a bitch) rebuild. Link is giving a 404 error.
  9. srafj40

    Help quick please 24 mm expansilon plug ?

    Need some real time help Saturday the 17th of January, If anybody has information on parts # Dealing with a freeze/expansion plug problem and need to check if this is the right part #90330-24013???? It is part of the oil circuit. 24mm on the front, mid-block to the left of the crank and cam...
  10. srafj40

    2f rebuild kit ?

    With the US $ nowadays that is like $20,000 right.:D
  11. srafj40

    2f rebuild kit ?

    Any suggestions on who to get a good rebuild kit from for the 2f? Pulled the engine today and will be assessing the damage in the next few days. Thanks in advance.
  12. srafj40

    Rod bearings

    Talking about these ones: https://forum.ih8mud.com/showthread.php?t=168809&highlight=rod+bearing https://forum.ih8mud.com/showthread.php?t=184004&highlight=knock
  13. srafj40

    Rod bearings

    Have a knock that I have been chasing. Dropped the pan and replaced the bearings. Started it up and the knock was gone... (good job smiles all around/drink a beer) ...until it warmed up. Could I need an oversized set or do you think it is deeper/main bearing, cam, etc...? Please...
  14. srafj40

    Help...need an emgine wiring guru, oh and i hate commies :)

    You've got mail. Check PM
  15. srafj40

    sounds like lower end rod knock but only at idle

    Bump: Need this for quick reference :doh:
Back
Top Bottom