reviving an old thread, but you wouldn't happen to know what the correct part number for the 1hx bell housing and input shaft are? I am having the same issue with the extra 2" from the firewall with my swap.
Thanks,
So, looks like the bellowing is about the same length as the one I've got on the tyranny already. I was hoping it would be shorter since I need to find almost 2 inches somewhere to get the 1hz to fit where the 1pz used to be. From reading your posts, you probably know if there is a bellhousing...
The 70 has 6 lug hubs up to 97, I think....and I'm pretty sure you are right about the only difference between the 70 and 80 series axles is the length of the half shafts.
I'll bring some tequila when I see my friend...that usually helps him negotiate!
Thanks for the picture, now I've got to...
Since I just realised that the 1hz I've spent the last year rebuilding to put in the Pzj77 won't fit (a real palm in face moment, let me tell you!) because of the length of the bellhousing and input shaft, I would trade pretty much anything with you. Unfortunately, I only have a couple JDM 70...
i've got a 151 from a 92 pzj77 and am looking for the bellhousing and input shaft for a 1hz if you're still looking. I think the pz-r151 bellhousing is like 2" longer than the one for the 1hz.
I had watched the video you had posted earlier. It is helpful. I have done it as the book says, but it hasn't worked out so far. I will keep you posted as to the issue when I figure it out.