Recent content by Sorians

Hi Guys thanks for all the comments.. It was the inner oil seal, Replaced this when I did the bearing but I must have pinched it when I was putting the Axle back in

The grease seals?

Hi Guys Did my wheel and knuckle bearings a fortnight ago and I've just noticed the passengers side is weeping grease. Drivers side looks good. Any idea what may be causing this? Thanks.

Thanks for such a fast and detailed reply :)

Is it okay to take the tensioner I have circled in the photo off to help get the belts off easier?

Did a bit of research and I have the part number Nut - 90171-14042 - Toyota Parts Deal Cotter Pin - 90252-03005 - Toyota Parts Deal

Thanks mate! if i ask for a 17mm castle nut at the auto parts store hopefully they will sell them seperately.. I think its 17mm if i remember correctly

Hi Guys i'm just wondering if there is a specific name for these bolts? And if anyone has the OEM factory part number for these?

Next week I'm putting my cruiser in to have the rear main seal and clutch replaced. Is there any other major seals/bearings I should get them to replace while they have the transmission off?

yeah thinking of going the leave it route for most of it but clean it away from anywhere with rubber/seals

Ahh a hot water high pressure hose.. that’s kinda out of my budget unless you can hire them

Hotsy?

Hi guys so the undercarriage of my 80 is covered in oil. I have fixed all the oil leaks that came with the car from the previous owner. Is it worth cleaning the oil off everything or just try clean any parts with rubber etc? if so what is the best method for this type of cleaning? Does a steam...

😂😂🤙🏽

Thank you for the replies everyone. I think I will just stick to what I put in last change.. 15w-40 semi Penrite oil