Recent content by SliderJack

  1. SliderJack

    Machine shop for head work

    Still happy with the work? I need to go through my 2f again.
  2. SliderJack

    Machine shop for head work

    Still happy with the work? I have oil in my coolant and need some work done...
  3. SliderJack

    Need Help with 78 2F - New Rebuild - Antifreeze in Oil

    Yes, head had cracks in the runners. Replaced it with another head.
  4. SliderJack

    78 FJ40 2F Idle Problems

    That was it. Purrs like a kitten now. Almost 1am here. Little late for neighbors but I'll try and get her tuned tomorrow. Pulling better vaccuum now too! Yeah!
  5. SliderJack

    78 FJ40 2F Idle Problems

    This is probably the culprit. The gaskets on the insulator block are upside down and blocking the idle circuit passage.
  6. SliderJack

    78 FJ40 2F Idle Problems

    Power valve and washer in question.
  7. SliderJack

    78 FJ40 2F Idle Problems

    Jets appear clean and not gummed up. Accelerator pump plunger is a little sloppy. Replacement plunger fits the bore tighter but a bit shorter. Top center, should power valve have that washer? Washer seems galled. I dont see it in carb diagram. Original plunger looks a little rough.
  8. SliderJack

    78 FJ40 2F Idle Problems

    Leak down test warm. Crappy china freight tester, hard to get consistent results but should be in the ball park. Numbers were all in green ok range
  9. SliderJack

    78 FJ40 2F Idle Problems

    Thanks. Totally stripped it down. Shot carb cleaner through everything and followed with compressed air. I didnt dip it though or use a sonic cleaner, which I'm considering. Tried another new carb recently though and had same results. But I'm willing to do whatever is needed. Weird that the...
  10. SliderJack

    78 FJ40 2F Idle Problems

    Put new NGK plugs in. Verified gap at .040.
  11. SliderJack

    78 FJ40 2F Idle Problems

    Thanks for your replies! I did a little more work tonight. See comments below. I've sprayed carb cleaner in these areas and didn't hear any change. Is there a better way? I don't have smoke. I did look over the intake manifold when I assembled, but not lately. Would I still pull vaccuum 10-15...
  12. SliderJack

    78 FJ40 2F Idle Problems

    Rebuilt truck and motor. Got it back on the road last year. Runs great for a period of time but now wont idle without choke. Aftermarket Trollhole carb. Took it apart and cleaned out ethanol gunk from jets. Was good for a bit, but rough again. Been running non ethanol and additive. New gas tank...
  13. SliderJack

    Parting Out 1976 parts fj40

    Whoops, dead ad.... saw it had a recent responsed. Not an easy way to delete my messsage. Thanks for the heads up.
Back
Top Bottom